I don't have a video that shows how to install the Trailer Wiring harness part # C59496 on your specific vehicle. But I do have a video that shows this product being installed on a similar vehicle that will give you the basic idea on how it installs. I also attached installation instructions. view full answer...
The Rhino Rack # RRVA126B-2 provides the crossbars, but you'll also need the feet # RRRLKVA, and # DK061 clamp kit to attach the feet to the roof of the vehicle.
The clamps attach to the top of the door jambs of the front and rear doors. The clamps are very thin, so they will not affect the operation of the doors in any way, but they're very strong, so there's no fear of the rack coming loose as long as it's been correctly installed according to the instructions.
I've edited a photo... view full answer...
Yes, the Hopkins Heavy-Duty ArcticGuard Snow and Ice Windshield Cover part # HM17529 will fit your 2005 Buick LeSabre and will do an excellent job of keeping the snow and ice off of your windshield. As you can see from the sample install video, the process is very simple. Just throw the cover over the windshield and secure it inside the vehicle using the included hooks. You can then tighten the cover with the straps for a better fit. The hardest part will be just throwing the cover over... view full answer...
Valterra ABS water tanks like the # R8024 are baffled every 18" for surge control and made from lightweight ABS plastic, so they're just not designed to handle to additional pressure that is created from an electric water pump sucking the water out of the tank; the # R8024 will only have a single baffle. Using an electric water pump would void the manufacturer's warranty in the event of any malfunction, but you can use this on a hand primed water system.
In regards to the surface that... view full answer...
In order to install this Draw-Tite Receiver Hitch, part # 36309, you will need to remove the rearmost fastener which secures the load leveling control housing to the frame rail and discard it. You will then trim the load leveling control housing around where the previously removed fastener was. See the picture to the right for further clarification.
Some other items you may need:
Draw Bar # 36063
Ball # 19258 or 19256
Trailer Wiring # 119176KIT view full answer...
Go To Results