I recommend the Redarc Tow-Pro Elite Brake Controller for Tekonsha Harness item # RED63RR. This brake controller and harness will install inside your Silverado without cutting or splicing wires using the Tekonsha Plug-In Wiring Adapter item # 3064-P. This set up fits all of the Chevy Silverado's that come with the factory tow package.
I really like this brake controller because it has a unique installation method where you can mount the control knob on your dash or console and hide the... view full answer...
The BAK Revolver X2 Hard Tonneau Cover # BAK39121 referenced in your question has an overall installed weight of just about 90 pounds.
I have attached a short video demonstration on this particular tonneau cover that you can also check out. view full answer...
As far as height goes for the Demco HiJacker 5th wheel hitch # DM8550034 the minimum measured up from the base rails in the truck bed is 15-1/4 inches. You should not have a problem closing the Tonneau cover on your 2015 Chevy Silverado 3500HD depending on the type of cover it is. Should there be an issue you can easily unpin the head from the base and set it aside.
The overall width is approximately 31 inches and the overall length is approximately 35 inches. I have included a picture... view full answer...
The Husky Liners Custom Rear Mud Flaps # HL57871 are a confirmed fit on your 2016 Chevrolet Silverado 3500 dually so long as it does NOT have the factory fender lip or add-on fender flares.
I went to our warehouse and measured this for you to provide the dimensions you were asking for. Please refer to the linked photo I prepared for you. You can compare these dimensions against your fenders to estimate how far down the flaps will extend. view full answer...
Welcome back! The Timbren Spacer Kit item # T68MR is exactly what you need. They have a 3/8" bolt hole opening that will work with the Timbren item # TGMRCK25D you purchased awhile ago. Timbren recommends a 1" gap between the jounce spring and your axle. view full answer...
The B&W Companion OEM 5th Wheel Hitch w/ Slider # BWRVK3775 weighs approximately 251lbs. The head # BWRVC3006 is detachable to make it a bit easier to lug around and weighs about 70lbs. The base # BWRVB3775 weighs approximately 181lbs. view full answer...
The Lippert Trailair Air Ride 5th Wheel Pin Box # LC158778 is intended to replace either of two specific OEM pin boxes, a Lippert 1621 or 1621HD, and measures 28-11/16-inches from the rear outside edge of the mounting plates to the center of king pin. You can see this in the linked photo and compare to your current pin box.
This king pin includes an air spring and shock that will eliminate much of the chucking and road shock you feel now with your OEM pin box and not only will it cushion... view full answer...
The combined weight of the Demco Hijacker Autoslide 5th Wheel Trailer Hitch w/ Slider - Single Jaw - Underbed # DM8550022 and the rail kit part # DM8551010 that fits your 2019 Chevy Silverado 3500 short bed is 374 lbs.
You should note that this does not count against your payload as that is the weight capacity of the truck bed whereas this attaches to the truck frame directly for supporting the weight. view full answer...
Yes, we do have a set of air bags that will fit your 2023 Chevy Silverado 2500 that is compatible with the factory puck system or an in bed hitch. These air springs fit both the 2WD and 4WD models and also fit the duallys.
I recommend the Firestone Ride-Rite Red Label Extreme Duty item # F2709. These air bags have a 7,500 lbs capacity that will keep the rear end of your Silverado level when you are towing your 5th wheel trailer. All mounting brackets and hardware are included for installation.
I... view full answer...
Since your 2021 Chevy Silverado has the shorter bed and the factory puck system, I highly recommend the B&W Companion OEM 5th Wheel Hitch w/ Slider item # BWRVK3775 you were looking at. The Companion Slider has a 20,000 lbs capacity and will give you 12" of travel for making tight turns and backing.
The Companion's 1" thick dual jaws will give you a 360-degree jaw to kingpin contact. This system minimizes the chucking, jarring and noise that can occur when towing a fifth wheel trailer.... view full answer...
Yes, it is! The MORryde item # MR87VR (our part number which is the RPB72-1116) and the Trailair Air Ride 5th Wheel Pin Box item # LC155943 both fit the Lippert 1116 bolt pattern. You will have no problem swapping these pin boxes out on your 2018 Keystone Montana. view full answer...
Thanks for your patience. It took a few days to get the measurements for the Curt Trailer Hitch item # C96CR. I have linked a diagram I made below.
The Curt item # C96CR is a class V hitch with a 2-1/2" receiver. It has a 20,000 lbs towing capacity and a 2,700 lbs maximum tongue weight. This hitch is confirmed to fit the 2022 Chevrolet Silverado 3500 and bolts to it with included hardware. view full answer...
No, sorry you can't. The head of the B&W Patriot Slider item # BWRVK3270 is different then the Companion and not compatible. Also none of the puck system adapters that provide an industry standard base are compatible with the Patriot because of how low the slider base is.
To use a B&W sliding hitch in your new 2021 Chevy Silverado 3500 with the factory puck system you will need the B&W Companion OEM 5th Wheel Hitch w/ Slider item # BWRVK3775. view full answer...
The BulletProof Hitches 2-Ball Mount # HD254 is 3-1/2" wide from the outside of the channel to outside of channel. I have included an image showing you where I measured this.
We do have the InfiniteRule Locking Pins # 34061674-D which are stainless steel and can fit a span up to 3-7/8". These 3 locking pins are keyed alike so you will not have to keep track of multiple keys for the hitch as well as the receiver locking pins. view full answer...
The Reese 5th Wheel Rail Adapter for Chevy/GMC OEM 5th Wheel Towing Prep Package # RP49FR that you referenced will add 2 inches to the overall height of your fifth wheel hitch. view full answer...
Your picture didn't come through so I can't tell you if you need shim plates but I can confirm that both the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box item # GY58FR and the Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter item # RP89FR fit the 1621 pinbox. So if your Keystone Fuzion 379 has a 1621 pinbox either of them will work.
The Gen-Y item # GY58FR weighs 162 lbs.
The Reese Goose Box item # RP85FR weighs 170 lbs.
I recommend going with the Reese over... view full answer...
Just the head on the Reese M5 5th Wheel Trailer Hitch # RP30890 that you referenced weighs about 48 pounds. The base and legs weigh 105 pounds.
This 20K fifth-wheel hitch is confirmed to fit your 2018 Chevy Silverado 3500 that features the factory rail kit. It will mount directly to the factory pucks in your truck bed and it has a premium single-piece Talon jaw that will wrap completely around the trailer king pin for a secure connection.
I have attached a short video demonstration on... view full answer...
The crossbars for the Rack'Em Fitz-All Enclosed Trailer Ladder Rack # RA-28 measure 1" wide x 2" tall (see attached).
I'm linking an installation video for you to check out as well! view full answer...
The Westlake ST235/85R16 Radial Trailer Tire part # LHWL410 is rated for up to 4,400 lbs when filled to 110 psi on a non-dual rear wheel trailer. The Goodyear Goodyear G614 Radial Trailer Tire is rated for up to 3,750 lbs when filled to 110 psi on a non-dual rear wheel trailer.
Even though the Westlake # LHWL410 is not made in the USA, they are very highly rated by our customers. Regrettably, I do not currently have any Goodyear to offer you in the size that you need. view full answer...