bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Scion iA


  • How to Find Correct Replacement Bearing Kit for 1995 Shorelander Trailer
  • The best way to determine what bearings will fit the hubs on your 1995 Shorelander trailer is to remove the hub and find the numbers that should be stamped onto the bearings themselves. If you cannot locate the numbers, you can also measure the spindle at various locations. I have attached an image that shows which measurements are needed. I recommend using a digital caliper like PTW80157 because the measurements will need to be as exact as possible. I have included a great article on...
    view full answer...

  • Should Power Wire for Powered Trailer Wiring Run Through Interior or Exterior
  • When routing the power wire for the install of a powered trailer wiring harness like part # C56311 you have the option to run it through the interior and then out through the firewall or you can run it to the outside of the vehicle at the rear of the vehicle through a grommet in the trunk and then route it up to the battery that way. It really depends on how you would prefer. Most commonly through the exterior is the method used. I attached a help article that covers the topic of running...
    view full answer...

  • Trailer Hitch for a 2016 Scion iA
  • Trailer hitch # 24815 does not fit your 2016 Scion iA but you can use Curt trailer hitch # C11421. The other hitch fits older and different Scion models just not your iA. If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class I trailer hitch. Also, with a bike rack, you are limited to 2 bikes maximum on a Class I hitch. Curt also says you have to use stabilization strap # 18050 when using...
    view full answer...

  • Bike Rack for Class I Trailer Hitch on 2016 Scion iA
  • The Curt Hitch # C11421 that fits your 2016 Scion iA is a Class I hitch with a 1-1/4" receiver, which means you need a bike rack with a 1-1/4" shank that is compatible with a Class I hitch. Please note that you are also limited to carrying two bikes with a Class I hitch. I highly recommend checking out the Hollywood Racks Trail Rider # HR200Z, which uses padded hooks to grasp your bikes by the top tubes and adjustable wheel mounts with straps to secure your rear wheels. It has a mast which...
    view full answer...