Actually, there are 4 trailer hitches available for the 2010 Toyota Yaris Sedan. I have included a link to them for you to view. And you are correct, both the Draw-Tite # 24819 and the Hidden Hitch # 60209 (no longer available) will fit. The difference between these two is that the Hidden Hitch, # 60209, comes with the correct ball mount, pin, and clip. With the Draw-Tite Hitch, you would have to purchase them separately.
You actually save a little money when going with the Hidden Hitch.... view full answer...
I recommend the Curt hitch, part # C11480, for your 2018 Toyota Yaris. Curt requires a support strap, part # 18050, when using a cargo carrier or any other non-trailer load.
I've linked the install details of the hitch for you. It's a fairly straightforward process. You do need to remove some plastic rivets and trim off a plastic tab from the fascia. view full answer...
After looking over the installation instructions for both hitches, it appears that installing the Curt Class I receiver, part # 11060 might be a bit easier than the Draw-Tite model. The upper bolt holes for the Draw-Tite will be a bit difficult to reach, and the hitch must be rotated upwards to maneuver it behind the bumper fascia. The Curt receiver simply attaches to the inside of each frame rail.
The install times mentioned all three hitches are identical. If I had to choose, I would... view full answer...
Curt trailer hitch # C11480 actually will replace C11050. Hitch # C11480 is the newer design and the model I recommend for you due to slight design changes.
If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class I trailer hitch. Also, with a bike rack, you are limited to 2 bikes maximum on a Class I hitch.
Curt also says you have to use stabilization strap # 18050 when using this hitch for... view full answer...
Go To Results