No you do not need to worry about the airbags going off on your 2020 Cadillac XT4 while installing the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # C39FR.
Frontal air bags are generally designed to deploy in "moderate to severe" frontal or near-frontal crashes, which are defined as crashes that are equivalent to hitting a solid, fixed barrier at 5 to 15 mph or higher. Or hitting a parked car around 15 to 25 mph or higher.
If you do want to be totally sure there will be... view full answer...
There is no type of fascia cutting or trimming necessary whatsoever to install the Curt Trailer Hitch Receiver # C39FR on your 2020 Cadillac XT4. The fascia has a removable panel which will allow you to access the trailer hitch when you need to and put the panel back on when you aren't using the hitch. The fact you can remove that panel and easily access the hitch is why you don't need to trim or cut any fascia.
I have added a link to the instructions for you to check out as well of the... view full answer...
For your 2019 Cadillac XT4 the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # C39FR is the correct fit. The installation details state the following for removing the fascia:
a. Open the lift gate.
b. Remove the plastic cover next to the tail light (each side) by pulling upward to release the clips.
c. Using a T20 torx remove the screws connecting the fascia to the vehicle (each side).
d. Remove the wheel well trim using plastic fascia removal tools. Carefully pull the trim... view full answer...
Yes, you will be able to reinstall the bumper cover for an OEM look on your 2021 Cadillac XT4 after installing the Curt Trailer Hitch Receiver # C39FR. I have attached an installation video for you to see the finished product.
If you don't already have a bike rack, then I recommend checking out the Kuat NV 2.0 Base Bike Rack for 2 Bikes # BA22B because it has a sleek matte black finish and has built-in features that make it one of the nicest bike racks to use.
I've attached an installation... view full answer...
The Curt trailer hitch for your 2019 Cadillac XT4, part # C39FR, actually installs on the same existing studs and with the same hardware that the factory bumper beam uses. During the installation the bumper beam is removed and the hitch fits over the studs. Then you reinstall the bumper beam over the hitch and fasten them both with the same M10 nuts that you would have removed to take off the bumper beam. So, there are no holes to drill into the Cadillac's frame.
The install details... view full answer...
You will be able to re-install the rear panel on your 2020 Cadillac XT4 after installation of either hitch that fits your vehicle, the Curt Trailer Hitch Receiver # C39FR.
Additionally, if you plan on towing and need a trailer wiring harness, the right one for your '20 XT4 is the T-One Vehicle Wiring Harness # 118795. view full answer...
Yes, once the Draw-Tite Max-Frame Trailer Hitch Receiver # 76266 is installed on your 2022 Cadillac XT4 you'll be able to place that rear bumper fascia cover back over it for an OEM look.
I'm attaching an installation video and some photos for you to check out about this.
If you're planning on doing some towing with this hitch then I also recommend picking up the T-One Wiring # 118795, the Mount Bracket # 18144, and the Ball Mount Kit # C45154.
Attached are some additional videos for... view full answer...
Go To Results