If your 2007 Suzuki XL7 has a factory tow package, then you can use the Curt T-Connector Custom Fit Vehicle Wiring, # C56012. The location point you have described sounds like the correct connector, jack storage compartment on the driver's side. This harness includes the necessary fuses and relays so that the harness will work. I have included a link to the installation details below.
If you end up needing to use Draw-Tite Wiring, # 119178KIT, you should not have to worry about voiding... view full answer...
You are correct. The Curt trailer hitch # 13518 is a bolt-on installation and no drilling is required. I have included a link to the installation instructions for you. You will see that there are bolt holes on the frame of your 2009 Suzuki XL7 where the hitch will attach. All of the hardware to attach the hitch is included.
If you plan on doing some towing I recommend the etrailer ball mount kit # 989900. It comes with 2 ball mounts, 2 balls, a hitch pin and clip, and a carrying bag. For... view full answer...
I have not heard of any problems when installing a brake controller on a 2007 Suzuki XL7. The issue you heard about may have been due to hooking the red stoplight switch wire from the brake controller up to a wire dedicated to the cruise control system. I have heard of problems with the cruise control wiring on the XL7. A brake controller only draws a small amount of current from the stoplight circuit for activation of the brake controller. The actual power sent to the trailer brakes comes... view full answer...
Go To Results