It is not necessary to have your 2021 Kia Seltos up on a lift or jack to install the Curt Trailer Hitch Receiver # C65FR.
It may be slightly easier given you'll have more room if you were to use something like the FloTool RhinoRamps Max Vehicle Ramp Set # FT11912MI and Wheel Chocks # FT11930MI but it is not necessary for the installation.
I have added a link to the installation instructions for you to check out as well of the Curt Trailer Hitch Receiver # C65FR. view full answer...
We have not yet had a chance to install a hitch on a 2021 Kia Seltos, specifically the Curt Trailer Hitch Receiver part # C65FR so I do not know specific ground clearance measurements. However, you will not have the same clearance issues you had with the Kia Soul with the Curt trailer hitch on a Seltos. The Seltos has about a 1-1/2" more ground clearance in the back compared to a Kia Soul. The Curt hitch also sits flush with the bumper and does not hang down. I have attached an installation... view full answer...
Yes, the Thule EasyFold XT Bike Rack for 2 Electric Bikes - 1-1/4" and 2" Hitches will work with your 2 Specialized Como 3 step-thru bikes. Your bikes' frames will be able to attach to the adjustable cradles on the mast of the rack. One thing to note about the EasyFold XT is that it has a maximum per-bike weight capacity of 65 pounds. I recommend you check with your bike's owner's manual to confirm that your weight falls under this maximum. view full answer...
Yes, we do have a hitch that fits your 2024 Kia Seltos.
The Curt Trailer Hitch Receiver # C65FR is confirmed to fit and has a bolt-on, no-drill installation. It will provide you with a Class 1 hitch with a 1-1/4" hitch receiver. view full answer...
Yes Thule roof carriers can attach to Rhino Rack roof racks like the part # RRVA126B-2 and # RRSX100 that fits your 2021 Kia Seltos. view full answer...
Thank you for your purchase of the Thule roof rack (parts listed below) for your 2022 Kia Seltos, and I'm glad to hear you're happy with it!
If the car wash is a manual one where the power washer is being operated by hand then you can leave the roof rack on. You'll need to remove the rack for an automatic car wash though because the machines might not recognize the rack and they will make contact and damage it.
It would be much easier to leave the rack installed, but I always like to... view full answer...
In this case the best hitch for the 2024 Kia Seltos is the only hitch available and that is the Curt Trailer Hitch item # C65FR. This hitch is custom fit and bolts to your Kia with included hardware. This is a class I hitch with a 1-1/4" receiver. It has a 2,000 lbs towing capacity and a 200 lbs maximum tongue weight.
I really like this hitch because the crosstube is hidden behind the rear bumper cover. This leaves only the 1-1/4" receiver visible. This not only looks better but it also... view full answer...
For your 2021 Kia Seltos with raised rails the Malone Air Flow 2 part # MPG215 is a confirmed fit and would work well. The Malone roof rack kits are really a great value. They are a fraction of the price as other similar quality racks and they work great. view full answer...
I have a great solution for you. You are absolutely justified to have a concern about the fitment of the Malone AirFlow2 # MPG215 on a 2022 Kia Seltos with flush factory rails. I confirmed with Malone that they do not currently do not have an engineered fitment of any Malone system (including the AirFlow 2) on a 2022 model Kia Seltos.
With that being said, I confirmed with Thule that this crossbar setup will be a great fit for your 2022 Kia Seltos with flush rails:
- Thule SquareBar... view full answer...
For your 2022 Kia Seltos there are only 1-1/4 inch hitches available like the Curt hitch # C65FR. The larger 2 inch hitch size is only available for larger vehicles like trucks and SUVs. It might be best to go with a bike rack that fits this hitch size like the Hollywood Racks Trail Rider # HR200Z. view full answer...
In regards to the Curt Trailer Hitch Receiver part # C65FR which is a fit for a 2021 Kia Seltos, there is indeed trimming of a small under body panel required. This under body panel is just a protective covering on the passenger side. If you don't want to trim you can leave this off but the process is very minor. It's hard to say but it seems as if the panel would interfere with the hitch body. I have attached a photo of the required trimming as well as the install instructions. view full answer...
I have an answer for you. The recommended maximum Thule crossbar length for your 2021 Kia Seltos is the 50-inch Thule WingBar Evo Crossbars # TH711300 (silver) or # TH711320 (black). However, we do carry longer bars that are confirmed to fit your vehicle just fine from different manufacturers. With that being said, If you have the 53-inch Thule Wingbar Evo Crossbars # TH711400 (silver) or # TH711420 (black), you will be just fine.
As far as the feet you need for your Thule WingBars, you... view full answer...
We rate the install difficulty for the Draw-Tite # DT65GR on your 2022 Kia Seltos as a 5 out of 10, so it isn't overly difficult. Especially since you have done one before. There will be no drilling needed, but there is very minor trimming of a panel to finish the install and I included an image from the instructions showing what this entails. And again, it's very minor.
As to the wiring, I recommend going with the Curt Wiring Harness # C89KR. Though one wire will need to be run up to... view full answer...
No drilling into the frame of your 2021 Kia Seltos is required in order to install the trailer hitch receiver that fits it, the Curt Trailer Hitch Receiver # C65FR.
This is a bolt-on installation and uses existing holes in your Kia's frame to install, which is why you don't have to drill.
If you plan on doing some light towing with this hitch and your '21 Seltos, there are a few other parts you'll need, which are the following:
- Vehicle Wiring Harness # C89KR
- Curt Drawbar # C45521
-... view full answer...
The trailer wiring harness that fits your 2021 Kia Seltos is the Curt T-Connector Vehicle Wiring Harness # C89KR.
Along with the wiring harness, the trailer hitch that fits your '21 Seltos is the Curt Trailer Hitch Receiver # C65FR.
It sounds like you are planning to do some towing so you will also need the Curt Class II Drawbar # C45521 with Trailer Hitch Receiver Lock # C23517 or Pin and Clip # F-4 to secure it to your hitch. For a hitch ball you will need either 1-7/8" Hitch Ball #... view full answer...
I reached out to Thule directly and confirmed that the Thule WingBar Evo Crossbar 47 inch # TH711220 which is the replacement for the Thule AeroBlade will fit your 2021 Kia Seltos. Thule's recommendation was to not use your sun roof with the crossbar installed, but if you do use the sun roof make sure to go slow to avoid possible damage.
To install the Thule Wingbar Evo Crossbar # TH711220 on your 2021 Kia Seltos you will need the Rapid Podium Feet for Thule Crossbars # TH460R, and Thule... view full answer...
I recommend the Draw-Tite Sportframe Trailer Hitch Receiver # DT65GR for your 2023 Kia Seltos.The Draw-Tite hitch has a bolt-on installation and will give you the 2 inch by 2 inch receiver head opening. The trailer hitch has a maximum gross trailer weight up to 2,000 pounds and has a maximum tongue weight up to 300 pounds.
For the trailer wiring harness I recommend the Curt T-Connector Wiring Harness # C89KR You will also need the Curt Towing Starter Kit # C45554.
If you have any further... view full answer...
When it comes to installing a trailer hitch on your 2022 Kia Seltos I recommend The Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4 inch # C65FR this trailer hitch has a bolt-on installation - with no welding required. It has a gloss black powder coat finish that is over a protective base coat that offers superior rust resistance. The Curt hitch is made in The USA, and has a sleeker look.
The trailer hitch has a maximum gross trailer weight up to 2,000 pounds, and has a maximum... view full answer...
Yes, the Curt Trailer Hitch Receiver # C65FR is confirmed to fit all models of the 2022 Kia Seltos. This hitch is made in the USA, has a bolt-on, no-drill installation and will provide you with a Class I, 1-1/4" hitch for using hitch mounted accessories such as bike racks, cargo carriers and ball mounts.
If you plan to do any towing you will also want to pick up the Curt T-Connector Vehicle Wiring Harness # C89KR which will provide a 4-way flat connector to power your trailers signal lights. view full answer...
While we do have trailer hitch wiring for your 2021 Kia Seltos, wiring is vehicle-specific so will only fit the cars and trucks it is designed for. So the wiring for a Ford Focus won't fit your Seltos; instead, for a 4-way on your Seltos, here is exactly what you will need:
- Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C89KR view full answer...
Go To Results