Expert Answers about Mitsubishi Montero

• Trailer Lights Dim When Headlights and Turn Signal are Used on 2001 Mitsubishi Montero Using C55380
• It sounds like you have a ground issue. You will want to start off by checking all of the grounds on your trailer and making sure that they are securely connected with a clean metal-to-metal connection. Rust and sometimes paint can sometimes cause issues with wiring. Checking the ground on your 2001 Mitsubishi Montero is a good idea as well. Since it really sounds like a faulty ground connection, I doubt it is the converter unit in the Curt # C55380, but you can check that too by using...
  view full answer...


• Trailer Lights Not Working On Left Side of Trailer When Connected to 2000 Mitsubishi Montero Sport
• It sounds to me as if you have a ground problem too. You have done all of the testing and it points to ground so I think you most likely have a light mounting bracket that is not making ground to the trailer frame. If the brackets for your tail lights are bolted to the frame, take them loose and clean all of the rust and road debris out. Make sure when you bolt them back down that they are contacting bare metal on both the frame and the light bracket and that they are tight. If your brackets...
  view full answer...


• Trailer Lights Not Working Using Optronics Trailer Light Kit # TL29BK On 1995 Mitsubishi Montero
• Since you have tested the vehicle side connector and they work correctly, you have eliminated the vehicle side as being the problem. So you will want to check the trailer wiring and the ground connections on the trailer. The Peterson M545 trailer wiring kit you have mentioned uses a wishbone harness like the Optronics Standard Trailer Light Kit # TL29BK that we sell. This means it will have 5 wires coming out of the back of the 4-pole connector. That might be why it looks like it does...
  view full answer...


• Troubleshooting Primus IQ Brake Controller On 2006 Mitsubishi Pajero SUV
• The NC will be displayed on the controller if there is no trailer connected, when the manual override switch is adjusted. Per the instructions that should have been included with the brake controller, it states that if there is no trailer connected and the manual knob is activated, NC will be displayed. It appears as if the brake controller is working properly for you.
  view full answer...