Expert Answers about Yamaha Kodiak
- Will Backing Plate of Brophy D-Ring Tie Down Anchor # RR5K Prevent Anchor From Ripping Out
- Depends on the condition of the wood but the backing plate of the Brophy D-Ring Tie Down Anchor w Backing Plate # RR5K that you referenced is designed to distribute the weight so that it does not easily rip through the wood.
I attached a picture of what the backing plate looks like installed. If the floor is strong enough for the weight of your snowmobile it's going to be strong enough for the backing plate to be effective.
view full answer... - How to Mount the Superwinch Terra Series ATV Winch to a 2016 Yamaha Kodiak
- I do have a winch mounting bracket for your 2016 Yamaha Kodiak but the Superwinch Terra Series ATV Winch part # SW1135220 does not include the mounting bracket you will want to attach this winch to your ATV.
For this, you will want the Bulldog WInch Custom-Fit Steel ATV Winch Mount part # BDW15185 in order to mount the Superwinch winch to your ATV. This will give you a complete bolt-on installation with no modifications needed. The winch and mounting plate will work nicely with one another...
view full answer... - Availability of Scissor Steps That Mount Underneath the Camper
- The mounting bracket on the Brophy Aluminum Scissor Steps, part # AS24, is 25 inches long and 1-1/2 inches wide and should be placed 1/8 inch below the lowest part of the door on your RV for installation.
The steps I have that are made to bolt or weld onto the trailer frame are the Stromberg Carlson brand. They will only have single, double, and triple steps. I am including a link to a product page that will list all of the Stromberg Carlson steps I have available.
I also have the Outriggers...
view full answer... - Replacement Motor for Ventline model PH 100 CFM Range Hood
- For the PH100CFM the correct replacement motor is the part # BVD0278-00 that you referenced.
view full answer... - Winch Mount Recommendation for a 2002 Yamaha Kodiak
- For your 2002 Yamaha Kodiak the Bulldog Winch mount part # BDW15128 has been confirmed as a fit so it would work great.
This would work well with the Superwinch Terra # SW1145220 that you also referenced.
view full answer... - Why Are Inside and Outside of Trailer Tires Wearing
- The problem is that you are simply under inflating your tires.
If your tires have too much pressure then you would see the middle of the tread wearing quicker, but since it is the outsides that means you need more air pressure.
Trailer tires should always be inflated to the max cold pressure rating given by the tire manufacturer. In your case that would be 65 psi. Anything more or less means that you could experience premature wear plus it means that the weight capacity is unknown. If...
view full answer... - Replacement Jack Recommendation for Powered Lippert Jack that Was Over Extended
- Did you extend it to the point where the jack stopped moving but the motor was still making noise? If so, you over extended the jack and damaged the nut and screw. Unfortunately this jack does not stop automatically when it's topped out which will allow it to over extend and damage itself.
You'll have to replace the jack.
I think the best value for an A-frame tongue jack is the Stromberg Carlson # SC63VR which is rated for 4500 pounds of tongue weight. This is 1000 pounds more than other...
view full answer...
Go To Results