Certainly; since you already have a 4-way like the Curt # C56039 on your 2004 Mitsubishi Endeavor, you can add a 7-way with one kit:
- Universal Installation Kit for Trailer Brake Controller # ETBC7
The 4-flat will activate your trailer's lighting functions, and you'll then plug the 4-way into the 7-way that comes with the # ETBC7, which also gives you the wiring, circuit breakers, and rest of the hardware needed for installation. view full answer...
Yes, the Curt Trailer Hitch Receiver # 13113 is what you need for your 2011 Mitsubishi Endeavor LS. You might have to temporarily lower the muffler by removing the rear rubber hange, but we've found this to vary from vehicle to vehicle. I'm attaching a helpful article on moving a vehicle exhaust around to fit with a trailer hitch if you'd like to check it out.
Attached is an installation video for you to check out. If you let me know what you're planning on using the hitch for I'd be more... view full answer...
If you have the Curt # 13113 on your 2008 Mitsubishi Endeavor, it will be compatible with a 2006 model. This hitch will fit 2006-2011 model years of that vehicle. I've attached a video of the Curt hitch installation to assist as these hitches both install in the same locations according to the attached installation details. view full answer...
The Thule Passage trunk mount bike rack # TH910XT is a fit for the 2008 Mitsubishi Endeavor. However, it is possible that this or any trunk mount bike rack can cause abrasions or marks on a vehicle. I own a trunk mount bike rack and have not had this problem myself but it is a possibility.
What you will need to do is make sure that before installing the rack the vehicle is clean and the rack where it touches the vehicle is clean. You can also apply a coat of wax on the vehicle where the... view full answer...
According to Yakima, with factory crossbars on your 1998 Chevy Tahoe, you need to use Universal MightyMounts for Yakima Ski Mounts, # Y03590.
There are actually several ski racks that are a direct fit to the factory cross bars that run side to side on your 1998 Chevy Tahoe. Since you were initially interested in Yakima, I will list the available racks they have first. You can use the following Yakima FatCat EVO 6 Ski and Snowboard Carrier - 6 Skis/4 Boards, # Y03096.
Thule also has several... view full answer...
Hello, We have the Curt Trailer Hitch Receiver # 13113. It requires no drilling but you will need to temporarily lower the exhaust to properly and completely install the hitch. This Curt hitch is also rated for use with a weight distribution system.
If this will be for towing a trailer you will need a wiring harness like the Curt T-Connector Vehicle Wiring Harness # C56039. This will power the trailers lights and keep you safe and legal. And a Curt Towing Starter Kit for 2" Hitches - 2"... view full answer...
Go To Results