Expert Answers about Chevrolet Chevelle
- Recommended Dual Path Air Compressor and Air Bags for a 1967 Chevelle
- If you use a dual path air compressor like the Air Lift Load Controller Compressor System item # AL25856 you will be able to inflate the Air Lift Air Bags item # AL60844 individually. These air bags are confirmed to fit your 1967 Chevelle.
view full answer... - Electric Radiator Fan Less Than 2-3/4" Wide for 1967 Chevrolet Chevelle SS
- I do have a solution, but unfortunately all of the higher CFM fans are too wide for the space you have. The highest CFM is going to be 2,500 to be able to match that space. We have the following options available which all have a width of 2-5/8" and 2,500 CFM:
-Lo-Profile 12-1/8" Dual Electric Radiator Fan - Nylon Shroud - Puller - 2,500 CFM # FLX420
-Lo-Profile 12-1/8" Dual Electric Radiator Fan w Controller - Nylon Shroud - Puller - 2,500 CFM # FLX410
-Lo-Profile 12-1/8" Dual Electric...
view full answer... - MagnaFlow Exhaust Recommendations for a 1967 Chevelle Super Sport
- According to MagnaFlow, the Stainless Steel Crossmember-Back Exhaust System, # MF15897, will fit your 1967 Chevelle SS. This kit is a cross member back exhaust kit. My contact at MagnaFlow stated that you would need to fabricate or have a shop fabricate the section that goes from the cross member forward to the manifold or headers.
Part # MF15897 is a 3 inch kit but there is also a 2-1/2 inch kit, # MF15893. I have included a link to the installation details for both kits for you to view.
view full answer... - Can the Air Lift 1000 Drag Bags Be Inflated Separately?
- The Air Lift 1000 Drag Bags for Coil Springs item # AL60844 comes with everything you need to set the air bags up for dual path or single path. Dual path will allow you to adjust the PSI individually using separate valves.
view full answer... - Recommended Dual Electric Radiator Fan w/ Shroud for 1967 Chevy Chavelle
- For your 1967 Chevelle I recommend taking a look at the Derale 26" Dual High-Output Electric Radiator Fan # D16842. This is a dual electric fan measures 26 inches wide, 18 inches tall, and 2-3/4 inches deep. It is . It has a 4,000 cubic feet per minute rating. In terms of depth this is the lowest profile dual fan unit with shroud that we have available.
As long as you have the needed space on the vehicle to mount this unit, this will work great.
view full answer... - Can the Deka Battery Isolator DW08770 Be Used On a Boat
- Yes, the Deka Battery Isolator part # DW08770 can be used on a boat to separate the starter and auxiliary battery but you would need to mount it in a location that is least likely to get wet, like in a battery box, the NOCO Snap-Top Battery Box with Strap part # 329-HM318BKS.
view full answer... - Trailer Hitch Receiver Recommendation for 1970 Chevrolet Chevelle
- Although we do not have a custom fit hitch available for your 1970 Chevrolet Chevelle, I have a hitch that should work for you. Take a look at the Curt Adjustable Trailer Hitch Receiver, # C13701. This is a universal style hitch receiver that will fit frame widths of 18 inches to 51 inches and can be bolted or welded to the frame.
Since the frame of a Chevelle is not 51 inches wide, you will need to make sure that you have enough clearance past the frame for the longer cross tube or the...
view full answer... - Fit of Air Lift 1000 Drag Bags AL60844 on 1969 Chevrolet Chevelle
- The AirLift 1000 Drag Bags for Rear Coil Springs # AL60844 are a confirmed fit on your 2WD 1969 Chevrolet Chevelle. These are designed to pre-load the rear suspension for better traction and to keep the car level at launch. They may not totally eliminate wheel hop but they will certainly improve off-the-line performance. These bags are not offered in any color other than red.
The kit includes everything needed to install the bags, including manual inflation valves. You can add a compressor...
view full answer... - Instructions and Minimum/Maximum Air Pressure for Air Lift Drag Bags on a 1968 Chevy Chevelle
- The Air Lift Drag Bags for your 1968 Chevy Chevelle are # AL60844. The instructions are linked on the right hand side of the page for you (here and on the product page). The minimum air pressure is 5 psi and the maximum air pressure is 35 psi.
view full answer... - Powered Fans to Correct Cooling Issue with 427 Big Block in 1966 Chevrolet Chevelle SS
- For the sake of your really outstanding vehicle I want to suggest that first you investigate whether there is any issue with your coolant/water pump that could be causing the engine to run hot. A dual-fan set up with aluminum radiator should do a pretty good job of cooling even a big block 427. We can certainly help you with new cooling fans but if there is some other underlying issue involved that would best be squared away first. If there is an internal cooling problem then new supplementary...
view full answer...
Go To Results