Camco Power Defender voltage protectors, parts # CAM55301 and # CAM55306, have a bit more protection than the circuit analyzers, parts # CAM55310, # CAM55312, and # CAM55313.
Both the analyzers and protectors have diagnostic lights for faults but beyond that the analyzers are just surge protectors. The voltage protectors go a little further by detecting the voltage and shutting off if the voltage level falls below 102V or goes over 132V. The voltage protectors also reset themselves... view full answer...
We do offer several light-duty Class I hitches for your 2013 Audi A4 Sedan including the Curt # C11186 which does require you to use a support strap (for retaining your Curt manufacturer's warranty) when using the hitch with non-wheeled loads such as bike or cargo carriers. The other hitch brands do not have this requirement but just the same it would not be a bad idea to use a strap like # 18050 with any light duty Class I hitch.
I have linked the written installation instructions as... view full answer...
The three light-duty Class I hitches offered for your 2013 Audi A4 Sedan are shown on the linked page.
Curt hitches are unique in that some of their hitch models like # C11186 do require a stabilizing strap # 18050 whenever used with a non-wheeled load, such as a bike rack or cargo carrier. Some other brands do not have this warranty requirement.
This does not indicate any deficiency in the Curt hitch. All three products are virtually identical and all install at the exact same points... view full answer...
Both the Thule OutWay 3 # TH56BV and the Gateway 3 # TH78VR are confirmed fits for your 2010 Audi A4 Sedan and both share many of the key features that distinguish Thule carriers, such as the patented FitDial system, integrated locks for the bikes, dual folding arms, anti-sway bike mounts and a limited lifetime warranty.
Where they differ, and where the OutWay 3 takes the lead, is in terms of the speed and convenience of mounting on your A4. The OutWay 3 uses only two coated steel cables... view full answer...
The Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # C11448 and the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # DT24950 are rated for the same capacities and attach in the same locations. I recommend the Draw-Tite above the Curt for this vehicle because the Curt class I hitches require a stabilization strap # 18050 for any bike carrier, cargo carrier, or other accessory under their warranty.
If you will be towing, I also recommend wiring... view full answer...
Go To Results