I went out to our warehouse and measured the Replacement Lens for Petersen Clearance Side Marker Trailer Light with Reflex # PE95ZR, and measured 3-3/16" long, 1-5/8" wide, and 2-3/4" on center between the mounting holes. view full answer...
We'll start out making sure your RV has a hitch and wiring harness in case you don't already have them installed.
To add a hitch to your 2000 Newmar Mountain Aire RV, you will want the Curt Adjustable Trailer Hitch Receiver item # C13701. This is a universal hitch that has a 5,000 lbs towing capacity, which is just enough to tow your Traverse. There are no custom fit hitches for your RV.
For a 7-way you'll have to hardwire one in using the Universal Wiring Harness w/ ModuLite and Brake... view full answer...
All of the mounting holes for the RV Scare Light with 6" Lead, Surface Mount - White Base # RVSL31 are separated from each other by 8 inches. view full answer...
We do have RV cargo sliding trays that are 42 inches wide, but none that are 56 inches long, though there are a couple that are close, if you are able to go slightly longer or shorter. The closest available are 48 inches long or 60 inches long, and are from MORryde:
- 48" Long x 42" Wide: MORryde Sliding Tray for RV Cargo Compartment # MR73FR
- 60" Long x 42" Wide: MORryde Sliding Tray for RV Cargo Compartment # MR83FR
Both options have an 800 lb capacity and comes pre-assembled. If... view full answer...
The actual overall width of the MorRyde sliding tray part # MR69FR is the 28.74 inch figure. The internal tray dimensions are narrower at 25.85 inches. I confirmed this in the past when MorRyde sent me their dimensional drawings. view full answer...
The distance from the hitch pin hole to where the gusset meets the shank on the Curt # D900 is 4-1/4". Whether or not this will work will depend on how far down your hitch hangs. The greatest amount of clearance from the hitch pin hole is 7" in the rise position. I have attached a picture showing these measurements as well as others for your reference. view full answer...
There is 2-5/8" between the screw holes on the Optronics Trailer License Plate Light item # LP71CB.
I have linked a diagram below with additional measurements. view full answer...
The Round Cooking Rack # 324-000151 has a height of 2-9/16" and a diameter of 11-15/16". Check to make sure that'll work with your microwave and if so, you're good to go! view full answer...
Yes, you do. The wiring that comes with the Blue Ox Accessory Kit item # BX88308 only controls your towed vehicle's lights. You will need to add the Roadmaster Battery Charge Line Kit item # RM-156-25. view full answer...
The Replacement Wooden Toilet Seat with Slow Close Lid for Dometic Part-Timer RV Toilets - Tan # DOM23FR measures 15-1/2" long and 14-3/8" wide. view full answer...