The fitting you need is a type 1 like the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT - 20" # 100473-20-MBS. As far as the regulator, I recommend the Camco Vertical 2-Stage Propane Regulator - 160,000 Btu/Hr # CAM59313. If you need the supply hose, that is the # 37207-31255. It is important to note that this supply hose is for the standard 3/8" male fitting on the manifold. view full answer...
The only tandem axle lift kit available is the Correct Track Trailer Alignment and Lift Kit - Tandem Axle item # RR23QX. It is comparable to the Lippert system and will raise your 2021 K-Z Sportsmen Travel Trailer trailer height by 1-1/4" or 2-1/4".
If your axles are above your leaf springs you can always use an axle flip kit to gain 2"-3" of lift depending on how thick your axle is. If you have a 2-3/8" axle you will want the Dexter Trailer Springs Over-Under Conversion Kit item # K71-384-00.... view full answer...
The closest we can come to this size is the Replacement Red Lens for Peterson Oval Clearance or Side Marker Light w/ Reflector, part # 108-15R. This replacement lens measures 3-3/4" wide X 1-5/8" tall. I cannot guarantee this replacement lens will fit your rear running light that measures 3-3/4" wide X 1-3/4" tall. You can always replace the entire light with the
Optronics Trailer Clearance or Side Marker Light w/ Reflector - Incandescent - Oval - Red Lens, part # MC38RB.
I have included... view full answer...
The Lippert 126003 is a 3,500 pound hub/drum and has a bolt pattern on 5 on 4-1/2 inches. The Trailer Hub and Drum Assembly # AKHD-545-35-K will be the replacement you will need.
The hub and drum has an Inner Bearing # L68149 and an Outer Bearing # L44649. The bearings, races, grease seals, grease caps, and lug nuts are included. The hubs bearings on your trailer should be repacked and replaced every 12 months or at 12,000 miles whichever one comes first.
The Electric Trailer Brake... view full answer...
Over time leaf springs will stretch out with all the weight that are put on them. The 4-Leaf Double-Eye Spring for 6,000-lb Trailer Axles # e47SR will work for you but may be a little stiffer then your normal ride that you currently have because they're rated for a heavier weight.
The double-eye spring has a sturdy steel construction and has a spring capacity of 3,000 pounds and an axle capacity of 6,000 pounds. The nylon bushings are included.
When it comes to the rear brake line kit... view full answer...
We always recommend going with 10 Gauge Wire # 10-1-1 for the electric brakes. Technically 12 Gauge should work but since the wiring has to run a ways we go with the mindset that a slightly larger wire might possibly let a little more power through and give you a better connection.
You'll want to use heat shrink butt connectors # DW05745-10 for this installation. view full answer...
In order to get the correct snap pads for your 2021 K-Z Durango Half-Ton Fifth Wheel, you'll need to measure the diameter of your jack foot.
From here we can determine what snap pads will work for you, for example, if you measured 9" diameter, and you have round jack feet, then you can use the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet # SP54FR4
I have attached a webpage containing all of our RV jack pads. view full answer...
Based on what I have found, your 2018 K-Z Durango Gold 5th Wheel more than likely has 7,000 lb axles. I recommend verifying this information to be sure. Assuming that is correct, I recommend the Hydrastar Disc Brake Kit w/ Actuator for Tandem Axle Trailers # HSE7K-T1.
This kit is designed for 7k axles and uses a # 25580 inner and # 14125A outer bearing. The kit includes the disc brakes, Hydrastar actuator, and a brake line kit. Grease caps are available separately. If you want to use... view full answer...
The nuts and lock washers needed to install a 7 inch brake assembly to the brake mounting flange is part
# BRKH7 which includes enough hardware for 2 brake assemblies.
I'm not certain what you mean by 'drum without a hub'. If you're talking electric drum brakes, the 7 inch hub drums we offer are one integrated piece like # AKHD-545-2-2K which uses the L44649 inner/outer bearing or
# AKHD-545-2-1K which is compatible with the L44643 inner/outer bearing.
If instead you meant to say you... view full answer...
I have a solution for you, but I'm not aware of a storage cover that also will provide protection for the tires in the manner that you've mentioned.
From what I was able to determine from my research it looks like the 2005 KZ Coyote 20C is 20 feet long, so the Adco SFS AquaShed Cover for Travel Trailer - Up to 20' Long - Gray # 290-52240 would be a great choice; if your Coyote has a rear garage door then you'll want the Toy Hauler cover # 290-52271. The SFS AquaShed is a great cover for... view full answer...
Go To Results