Trailer tongue jacks can be rated for well under the trailer's actual weight since they never have to lift the entire trailer, only the weight of the tongue area at the coupler end. Usually in a properly-loaded trailer this will be between 12% and 15% of the trailer's total gross weight (GVWR).
Since your 2017 Jayco Jay Flight SLX A-frame travel trailer has an unloaded tongue weight (TW) of 710-lbs we can estimate that when fully loaded the TW will be more like 1000-lbs.
I think the... view full answer...
You'll find important information about your trailer tires right on the tire sidewall. This information includes the tire size, of course, as well as the Load Range letter code for weight capacity, the Speed Rating letter code and the inflation pressure.
For a radial tire only with a speed rating higher than 65-mph you might consider the Taskmaster 4.80R12 Radial Trailer Tire # TT48012C which fits 12 x 4-inch wheels and which has a speed code M, which means it is good to 81-mph. This tire... view full answer...
To replace a dexter 010-063-00 seal you will need the Grease Seals item # RG06-070 you were looking at. It's the same size and a good replacement option. Plus you get two. view full answer...
When the Taylor Made Gas Shock part # 3691843-20 is compressed it is right at 12 inches long and when extended it is 20 inches long. view full answer...
The dimensions of the Replacement Trailer Hub Bearing item # 25580 you referenced from the Dexter Trailer Hub and Drum Assembly item # 42866UC3-EZ are as follows.
Inside diameter: 44.450mm / 1.7500 inch
Outside diameter: 82.931mm / 3.2650 inch
Width: 23.812mm / 0.9375 inch
Cone width: 25.400mm - 1.0000 inch
Cup width: 19.050mm - 0.7500 inch
The depth of the bearing/cone width is 1 inch or 25.400 mm view full answer...
The Dexstar Steel Spoke Trailer Wheel - 15" x 5" Rim - 5 on 4-1/2 - White Powder Coat # AM20422 will absolutely be able to accommodate the 65 psi needed when upgrading to a larger tire.
To do this, all you need is the Americana Rubber, Snap-In Valve Stem - 1-1/4" Long - Up to 65 psi # AM20903. view full answer...
The weight rating of the Rhino-Rack 2 Bike Carrier # RR64QH is 33 lbs per bike and cannot be combined if you plan on only carrying 1 bike. If you were only carrying something like a 35 lb bike you might be okay with 1 bike (although we still don't recommend this) but doubling up the weight of the bike is way out of the question.
What you need is a hitch mounted bike rack designed to carry your e-Bike. If you let me know what vehicle you'll be using to transport your bike and whether it... view full answer...
The overall dimensions on the Rear View Safety Monitor Mount # RVS-Mount are 3.25" (H) x 4" (L) x 3.75" (D). So the base is about 3-3/4" x 4" and the arm is about 3-1/4". I attached a diagram below to show this better. This will fit most RVS monitors including 7" monitors. Let me know which model of monitor you have and I can check if this mount will fit. view full answer...
Since your tongue weight is right at 500 lbs the best Blue Ox SwayPro is the part # BLU36FR which has a tongue weight range of 200 to 600 lbs. The part # BLU67FR would be rated too high as it has a range of 600-800 lbs. If your loaded tongue weight was about 100 lbs more than what you have now this would work well but using the 500 lb figure it would be too high. You should keep in mind that any weight behind the rear axle of the tow vehicle gets counted as tongue weight.
If needed this... view full answer...
Trailer makers rarely keep track of smaller items like vent parts used in fabrication of their trailers so finding the right replacement part is often just a matter of measuring, as you have done.
Since we do have this item in stock, Ventline Exterior Wall Vent for RV Range Hood # V2111-03, I went to our warehouse to measure it for you. I put key dimensions on the linked photo that I prepared for you, including hole spacing.
I have some additional information that I could not easily add... view full answer...
The Alpha Systems Superflex TPO RV Roof Membrane # AL25CV is 0.30" thick. This is the only thickness they offer currently for the TPO. You will need the Alpha Systems RV Roof Replacement Installation Kit # AL63FJ to install this roof membrane. view full answer...
Yes, there is 15 teeth per each gear on the Replacement Gear Kit for etrailer and Ram Sidewind Jacks # TJA-2000S-GR. These gears have a thickness of 0.5", an OD of 1.36", and an ID of 0.5". view full answer...
You will need to contact Jayco directly with your VIN information to verify the exact capacity of the rear bumper on your 2016 Jayco Jay Flight SLX 145RB travel trailer. The Curt RV Bumper 2" Trailer Hitch Receiver # E-100 is capable of handling up to 350lbs of tongue weight so it is strong enough for your Swagman bike rack and 2 bikes weighing 90lbs.
Do be sure to verify with your bike rack you are not exceeding the weight the carrier is capable of supporting. The Swagman XP RV Bike... view full answer...
The lift from an over under kit like the part # K71-385-00 that you referenced gives you a lift of the diameter of the axle plus the thickness of the leaf spring pack. Since this is for a 3 inch axle it would be 3 inches plus the leaf spring thickness. Most likely around 6 inches. view full answer...
Tape measures are not as accurate a measuring tool as a digital caliper like Item # PTW80157. Based on your information, we know it will be a 10 x 2-1/4 inch hub. Another great way to find the right size is to match your inner and outer bearings which have their sizes stamped on them. It sounds like you will need 10 inch hub and drum like Item # AKHD-545-35-K that fits 3,500-lb axles with an inner bearing like Item # L68149 and and outer bearing like Item # L44649. Make sure to check... view full answer...
The tallest available exterior ladder we offer is the Stromberg Carlson RV Exterior Ladder part # LA-401 for silver or part # LA-401BA for black which measures 99-1/2" tall. That said, you can add an extension piece as well to get the ladder where you need it, the Stromberg Carlson RV Ladder Extension part # LA-148. view full answer...
It looks like your 2018 Jayco Redhawk 29xk was built on a E-450 cab and chassis. The Tekonsha Plug-In Wiring Adapter item # 22292 will plug into a port behind the instrument cluster finish panel in the center of the dash on the driver's side. I have attached some pictures below that will help you find it. You will be looking for a grey connector that has to be unplugged to expose the factory plug you need.
If it's not located there then your chassis may be an older one and you would need... view full answer...
At one point the Mighty Cord RV Extension part # A10-5050EH didn't have the finger grips for each of the connectors but now both sides do so what you saw would have been older pictures. view full answer...