On the Roadmaster MX Base Plate kit # 1541-5 that fits your 2003 Honda Element with 5-speed manual transmission the draw bars (arms) are directly compatible with all Roadmaster motorhome-mount tow bars like the Falcon All Terrain # RM-522 and others that slide into the motorhome hitch receiver.
If you refer to the photo I linked you can see the rounded ends of the draw bars. view full answer...
Assuming the measurement you took is correct, the # TLA7752 TorkLift Lock and Load generator/cargo tray will just fit. The shank on the carrier measures 6-1/2 inches from the center of the hitch pin hole to the closest part of the carrier platform, so there will be a 1/2 inch of clearance between the bumper and the carrier's platform. It'll be snug, but the carrier will fit. view full answer...
The Roadmaster base plates that fit your 2005 Honda Element are the Roadmaster Crossbar-Style Base Plate Kit # 1541-1 and Roadmaster Direct-Connect Base Plate Kit # 1541-5. You can get replacement bracket arms for either with the following:
- Roadmaster Replacement Arms for Base Plate Kits # RM-ARMS
Please note you'll have to click on the "Installation Details" link on the # RM-ARMS page and fill out the bracket form to get the right set.
As for the tow bar itself, a good option is the... view full answer...
To determine if your rear hatch will still open on your 2010 Honda Element with the Roadmaster Hitch Mounted Spare Tire Carrier # RM-195225 installed you will need to take some measurements. The carrier offers either 5-1/4" or 8-3/4" of clearance from the hitch pin hole center. The carrier is also 35-3/8" from the top of the receiver tube to the top of the carrier. Depending on the size and offset of your spare tire it will also need to be considered.
You will most likely need the Roadmaster... view full answer...
You will need to check your owners manual or with the car dealer to see if your 2006 Honda Element can be flat towed. Some vehicles must be equipped with a transmission lube pump, an axle disconnect, driveline disconnect or free-wheeling hubs before they can be towed. If the correct procedure is not followed it will cause severe damage to the transmission.
If you will be able to flat tow your vehicle, you can use the Roadmaster MX Base Plate Kit, # 1541-5, on your 2006 Honda Element to... view full answer...
Unfortunately, the etrailer 2-inch Class III hitch # e78KR is a not a confirmed fit on your 2008 Honda Element SC, as it only fits non-SC versions too.
The only hitch that we offer for your Element SC is the Curt Trailer Hitch Receiver - Custom Fit # C11699. This is a Class I hitch which has a 1-1/4" receiver opening. This hitch has a 200-pound maximum tongue weight and a 2,000-pound max gross trailer weight capacity.
If you also need a wiring harness to operate a trailer's lights... view full answer...
The first thing you will want to check in the owners manual or with the car dealer is the GCVWR (Gross Combined Vehicle Weight Rating). The GCVWR is the weight capacity for your vehicle, which includes the vehicle, trailer and the contents.
The Trailer Hitch for the 2009 Honda Element, # C11700, will only work on a 2009 Honda Element that is not an SC model. If your vehicle is not a SC model then it would fit and work fine for towing the 750-800 lb. trailer. The Gross Towing Weight on... view full answer...
I may have a solution for you, but according to my contact at Yakima the Spare Tire Carrier # Y07076 is not compatible with the Basketcase and there is not a tire carrier that will fit on the smaller bars. With that said, you could just use some ratchet straps like the CargoBuckle Mini G3 Retractable Ratchet Straps - 1" x 6' - 466 lbs - Qty 2 # IMF111640 to secure your spare tire. These ratchet straps will provide a bit more secure solution than the cargo net that was included with the... view full answer...
I called my contact at our supplier and asked about your 2006 Element. There may have been a change when the car was manufactured and the trailer wiring was added to your vehicle but we really have no way of knowing.
Our records indicate the trailer wiring harness for your Element is a hardwire installation. For that you would want part # C59496.
If you wish to try installing the T-One Harness, part # 118465 it may work just fine. We cannot guarantee this will work because it does not... view full answer...
Yes, the Curt trailer hitch receiver, part #C11700, is a Class I trailer hitch receiver. The Kuat Sherpa 2.0, part # SH12b works with Class I and Class II hitch receivers. view full answer...
The Kuat 2 bike Add-On, # NA22G for the Gunmetal Gray or # BA02B for the matte Black finish would work great with the hitch currently installed on your 2008 Honda Element. If you click the provided link, you can see a product demonstration video featuring the NV 2 bike add-on. view full answer...
You can use the Inno Wedge 660 Rooftop Cargo Box # INBRM660WH on your 2004 Honda Element EX. I am assuming that by "does it fit" you are referencing if you will be able to open the rear hatch with it installed.
In order to determine that, you will need to take a measurement. You will want to measure between the front crossbar and the line where the roof and hatch meet. In order to open the hatch with the cargo box installed, you will need a measurement of 48-1/2" or larger. Other than... view full answer...
The etrailer hitch # e78KR fits 2003-2011 Element models with the exception of 2007-2010 Element SC. It'll fit your 2009 Honda Element LX perfectly. The installation instructions were last updated in 2008, so they don't show the fits on the 2009-2011 models.
If you'll be towing with the hitch, you'll need a few other items to complete your towing system. You'll need a trailer wiring harness like # 118465, a ball mount like # D-28 and a hitch pin like # PC3 along with a trailer ball like... view full answer...
For the 2006 Honda Element, etrailer doesn't have sub-model specific information about if fascia needed trimming to install their # e78KR Class III hitch. The install directions state that for all models, some drilling will be required but no fascia trimming. The hitch sits below the bumper.
If you have the squared-off bumper that doesn't slant downward under the vehicle, then it could be possible that some trimming would be needed, but our directions say no trimming needed. Unfortunately,... view full answer...
In order to use your Falcon 5250 tow bar to flat tow your 2007 Honda Element you will need specific base plates, the Roadmaster Direct-Connect Base Plate Kit # 1541-5. I am not 100 percent sure what you mean by "purchase the base plate which was sold" with your Element, but you will need the Roadmaster base plates to use your tow bar.
I have added a photo a customer sent in which shows these base plates on their Honda Element so you can see how they will look when installed on your car. view full answer...
The wiring for the Roadmaster 4-Diode Universal Wiring Kit # RM-152-98146-7 that you referenced will feed through the side channel of your Falcon All-Terrain II but if you are needing more length than the 6-1/2' cord I have another solution for you.
The Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267 is the exact same thing except that it has a coiled cord instead of a straight one. The coiled design keeps it from dragging on the ground when you are flat towing.
When... view full answer...
The mounting hardware that comes with the Yakima MegaWarrior # Y07080 will fit on your Surco crossbars. The basket fits a crossbar spread (center to center distance from one bar to the other) of 30 to 38 inches. On your 2007 Honda Element the spread is around 29-1/2 to 30 inches so that will also be compatible with the MegaWarrior. view full answer...
The cable lock on the Yakima HoldUp, # Y02443, and the HitchLock, # Y07235, can be keyed alike. You will have to purchase matching lock cores, # Y07202, for a 2 pack, and use them and their keys in place of the locks and keys that come with each product. view full answer...
Yes, the Thule Passage 3 Bike Rack, # TH911XT, will fit your 2003 Honda Element. The weight capacity of this bike rack is 105 lbs for 3 bikes.
If you plan on carrying any womens or childrens bikes, then I would recommend picking up the Yakima Tube Top Adapter Bar, # Y02531. Some small or angled bike frames are difficult to mount on bike racks and this bar will allow you to mount the bikes safely and level.
I have attached review videos for this bike rack and adapter bar for you to check... view full answer...
Go To Results