bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Coleman


  • Recommended Replacement For An Atwood 31013 RV LP Detector
  • Since the Atwood 31013 LP Detector has been discontinued you can replace it with the RV Propane Gas Detector - 12 Volt - 2 Wire - Black # RS44FR. This detector is a surface mount design and can easily swap out your old unit in just a few minutes.
    view full answer...

  • Recommended Replacement Control Panel for Atwood G6A-8E Hot Water Heater Not Igniting
  • On your Atwood RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank # AT96121 it sounds like your control panel was struggling (erratic) and now has simply failed. You will need the Replacement Control Panel for Atwood Water Heaters # AT91367 to repair internal connections to get that ignition firing correctly again.
    view full answer...

  • Replacement Tail Light Options for 2016 Coleman Lantern Travel Trailer
  • It sounds like you are looking for a replacement passenger side tail light for your 2016 Coleman Lantern 274bh trailer by Dutchmen. If that is the case, we have exactly what you are looking for! From my research, it looks like those trailers came with incandescent lights, but could've been upgraded to LED, so I'll give you both options. For an incandescent light, you will want part # RVSTB60. For an LED light, you will want part # RVSTLB60 We also have the drivers side lights if you'd...
    view full answer...

  • Replacement Axle for Coleman Lantern Travel Trailer
  • The # T3584F-EZ-8974 axle you'd looked at is compatible with an L68149 inner and a L44649 outer bearing. If that's what your current axle uses (the bearings will have the reference numbers on the side of the bearing cage), then yes this axle will be compatible with your existing hubs, assuming they're still in good condition. You'll likely need replacement grease seals, as they'll be destroyed when you remove them to get the referenc number off the inner bearing. Assuming that the hub...
    view full answer...