Expert Answers about Chevrolet
- Where is Titan Chain 5/16 Inch Clevis Hook Made
- The Titan Chain Clevis Hook with Spring Loaded Latch for Chain with 5/16" Thick Links - 4,700 lbs # TCSLIP-G70-8-L you asked about is made in China.
For a similar clevis hook that is made in the USA you can use the Laclede Chain Clevis Hook with Latch, 5/16" # 6495-301-04
I have added links below to a couple video reviews for you to check out as well
view full answer... - Are the Buyers Products Mud Flaps Reinforced
- The Buyers Products Mud Flaps - Black Rubber - 24" Wide x 20" Tall x 1/4" Thick part # 337B2420LSP that you referenced are in fact reinforced with fibers running through them. I went to look at the ones in the warehouse and they are very heavy duty and will do a great job! The folks behind your will also be very pleased.
I've included a link to the video Ellen did to give you an idea of how they look and feel.
view full answer... - How Do I Know What The Capacity Of The Axles Are On My Trailer?
- Unless your axles were custom made/modified, the 3" diameter will denote an axle in the capacity range of 5,200 pounds (like the Dexter # 6340624) up to 7,000 pounds (like the Dexter # 8327834). If there was a previous owner of your trailer, they may have upped them to a heavier capacity, but even some manufacturers will equip trailers with heavier duty parts than needed. Especially if it is a newer trailer. Demand has been much higher than supply recently so I have seen a couple trailers...
view full answer... - Where is this Draw-Tite 75607 made?
- The Draw-Tite # 75607 is made in Mexico. If you are looking for a hitch that will fit your 2007 Chevy Colorado that is made in the US, you will want to go with the Curt # 13252. This is rated a little lower than the # 75607, but will still handle up to 4,000 pounds towing and 400 pounds of tongue weight.
view full answer... - How Much Does the Pace Edwards SwitchBlade Hard Tonneau for Chevy/GMC 6-1/2 Foot Bed Weigh?
- The Pace Edwards SwitchBlade Hard Tonneau Cover # 311-SWC95A17 you asked about will be under 70 lbs installed but I don't have that precise weight. It is 73 lbs when packed for shipping and will fit 2014-2019 Chevy Silverado or GMC Sierra 6-1/2 foot bed models.
I've attached a couple videos to assist with the installation and function.
view full answer... - Are the Brophy Trailer Cargo Control D-Ring Tie Downs # RR05 Zinc Plated
- I spoke with my contact at CR Brophy and the Trailer D-Ring Tie Down, Recessed 5K, item # RR05, is Zinc plated to resist rust and corrosion. I also inquired about the backing plate, item # BP05, for the D-Ring tie downs and it is also Zinc plated.
view full answer... - Is the Back of the K-Source Replacement Side Mirror KS62133G Glossy
- I'm not sure what you would call that on the back of the K-Source Replacement Side Mirror - Electric/Heat w LED Signal # KS62133G, and it doesn't extrude from the housing at all. I've attached a side photo to show it better. It definitely looks a bit more glossy than the rest of the housing, but I think part of it is the lighting too.
view full answer... - Can the BedRug VanTred Mat Stand Up to Carpet Cleaning Chemicals
- The top part of the BedRug van mat # VTRG96X is made of Poly(p-phenylene oxide) which can take a beating and the soap should not be a problem. But the other chemicals, I suppose it depends on what they are. Heavy acidic chemicals could wear it down. But all you would have to do is hose off the mat since the back is waterproof. If you wash the chemicals away at the end of the day it should last the life of the van.
From what I found the material is good with diluted acids, alkalis, fair...
view full answer... - What are the Soft Beret Style Mantles for Propane Lanterns Made Of
- I spoke with my contact at American Mantles to find out what they are made of. According to my contact, "The mantles are primarily made out of viscose rayon yarn. They attain the glow as the knitted tubular yarn is impregnated with a non radioactive rare earth called Yttrium Nitrate."
view full answer... - Where is Valterra EZ Coil-N-Store Drinking Water Hose Made
- The Valterra EZ Coil-N-Store Drinking Water Hose with Quick-Connects - 25' Long x 3/8" Diameter # W01-0022 is manufactured in Taiwan.
view full answer... - Who Manufactures The Westlake ST235/80R16 Radial Trailer Tire # WE76FR
- The Westlake ST235/80R16 Radial Trailer Tire # WE76FR is from Lionshead Specialty Tire and Wheel, which is manufactured in China. This is unlike most tires from China in they stand behind the quality of the tire with a 5-year warranty and 2-years of complimentary roadside assistance anywhere in the USA, Canada or Puerto Rico. This rivals and beats most US made tire companies for warranty periods.
view full answer... - What is the LaSalle Bristol RV Faucet Bezel Constructed of
- The LaSalle Bristol RV Faucet Bezel # 3449123035W (white) is made of a durable ABS plastic construction.
We also have this available in parchment color, made of the same ABS plastic construction.
- LaSalle Bristol RV Faucet Bezel # 3449123035P (parchment)
view full answer... - Will the Hex Nut # 936060054 Fit with the M6 x 25mm Carriage Bolt # 915-0625-54
- Yes, the Hex Nut # 936060054 that you referenced will fit the M6 x 25mm Carriage Bolt # 915-0625-54.
I spoke with my contact at Thule who said that they are metal (non-stainless steel) with a black powder coat glossy finish. My contact also said that he owns some Thule products that use this same nut and he has never seen any of them rust if that is what you are concerned about.
view full answer... - Purpose of Smaller Holes in Draw-Tite Hitch Receivers Between Opening and Hitch Pin Hole
- The Draw-Tite Max-Frame Trailer Hitch Receiver # 75607 has the smaller holes between the receiver tube end and the hitch pin hole. The smaller hole is no longer used. This is a locking hitch pin and anti-rattle device that Draw-Tite has the integrated holes to utilize. I've attached a couple of videos to assist.
It is a really nice option for ball mounts and other accessories that do not have an integrated locking/anti-rattle system to stabilize and reduce noise.
view full answer... - How To Tell If a 2003 Chevrolet Silverado Has Factory-Installed Fender Flares
- A factory fender flare is trim placed around the outside of the wheel well to both protect the vehicle from grime and road debris and enhance the vehicles appearance. I have added a typical photo of what fender flares look like.
The WeatherTech Mud Flaps # WT110005-120005 you referenced are compatible with your 2003 Chevrolet Silverado if they have the factory fender flares. I have provided links to the installation instructions for these mud flaps.
If your truck does not have the fender...
view full answer... - Erickson Ramps for Garden Tractor Loading
- The Erickson Arched, Aluminum Loading Ramp Set - Non-Folding - 90" x 12" - 3,000 lbs # EM07486 can support your tractor with you on it, although you are taking the liability if you choose to do so. The company makes their straps in Marine City, Michigan where they are headquartered but the ramps you asked about are made overseas to US specifications.
view full answer... - What Gauge Wire Does the Heavy Duty Magnetic Tow Lights Part # TL21RK Use
- I spoke to my contact at Optronics and they informed me that the Heavy Duty Magnetic Tow Lights part # TL21RK uses a 20 gauge wire. This will be standard for most magnetic tow lights for the exception of a few which can use an 18 gauge wire but that would be the thickness wire used in a set of magnetic tow lights.
view full answer... - Does the VanRug Custom Floor Mat Smell Cheap and Plasticky?
- I went out to the warehouse and opened the box that the VanRug Custom Floor Mat for Cargo Vans - Charcoal Gray - Carpet item # VRG96 comes in. I can confirm that it does not smell like cheap rubber and plastic from China. I consider myself to have a very strong sense of smell and got a very neutral fragrance from inside the box. I could only smell the cardboard the rug comes packaged in. This product was also made in the USA which might also explain the absence of any cheap plasticky odors.
view full answer... - Does Replacement Access Laredo Tonneau Cover Come with Hook and Loop Fastener Already Attached
- Yes, the Replacement Tarp for Access Lorado Soft Tonneau Cover # A42281 does come with the loop side of the hook-and-loop fastener already stitched onto the cover.
view full answer... - Replacement Breakaway Switch Made in the U.S.A.
- Yes, there is one option for replacement breakaway switch that is made in the U.S.A., which comes from Dexter Axle:
- Replacement Breakaway Switch with Cable and Pin for Dexter Trailer Breakaway Kit # K71-691
view full answer...
Go To Results