To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Ease installation of your electric trailer brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the built-in port beneath your vehicle's dash.
Features:
To install your electric brake controller, you need to connect the wiring of the controller to your vehicle. Certain auto manufacturers offer pre-wired options, typically known as tow packages, wherein wiring is run for you from the dash to the trailer connector on the back of your vehicle. When this is done, a port is installed at your dash so that you can easily plug in a brake controller.
This adapter plugs into the port on your vehicle's built-in brake control wiring harness. The harness is located underneath the dash, to the left of the steering column, and it is taped to another harness near the emergency brake pedal.
To hook this adapter up to your trailer brake controller, just connect the 4 wires of the harness - ground, power, brake switch, and brake power - to the corresponding wires on the brake controller. If your brake controller came with a plug built into its wiring harness, you will have to cut off the plug and connect to the wires themselves.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be reviewing Part Number TM75271. This is the TrailerMate custom wiring adapter for trailer brake controllers. It's going to allow you to have an easier installation of your electric trailer brake controller. All you have to do is connect the four wires on the harness to the brake controller wires with the included butt connectors and then plug the other end of the adapter into the built-in port beneath your vehicle's dash. This unit is designed to fit KIA vehicles. To see if this is going to fit your particular model and year, you can refer to the vehicle fit guide on our website. The pigtail wiring adapter is going to ease the installation.
It's going to be compatible with time delayed and proportional brake controllers from TrailerMate, Draw-Tite and Tekonsha. The wiring is going to be a standard copper wire, so it's going to insure a nice long life. The length of wire that we have from the base of the plug to the end of the exposed wire is going to be about twenty-four inches. TrailerMate is going to cover it with a limited lifetime warranty. You're also going to get a couple zip ties that's going to help secure the wires up and out of the way. Your white wire is going to be your ground.
Black wire is going to be for the battery. That's going to get connected to the positive terminal on the battery. Blue wire is going to send power to the trailer brakes. The red wire is going to be the vehicle brake signal. That's going to do it for review of Part Number TM75271. This is the TrailerMate custom wiring adapter for trailer brake controllers.
.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.