To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Anti-flicker harnesses prevent flickering and "bulb out" dash warnings for H7 LED headlight bulbs. Works with CANbus and PWM equipped vehicles. Plug-and-play installation.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey everyone. I'm Ellen here at etrailer.com. And we're going to be taking a quick look at the anti flicker harness for your H7 style bulbs from ARC. These are going to be a great addition to your vehicle. If you have a can bus or a PWM style electrical system, and you want to replace your lights. A lot of times what happens when you try to replace your lights with LEDs is that there's just not quite enough current to go through those lights to keep them on all the time.
So you get this kind of flickery, shuttery effect and it's just not great.So this is going to alleviate that problem. We'll have a nice constant light and you won't have any issues with that. So they're pretty easy to use. They just plug right in line with your light. So you can see that the two ends are going to match up with the end of the socket for your light bulbs.
So it's going to be a direct match for that H7 style. So if we we're to plug these in, they're just going to match right with each other.Your LED bulb is going to plug into one side. This side is going to plug into your vehicle. So there's no cutting or splicing required with these guys. They just plug right in line, make it pretty simple, plug and play installation into your existing wiring.
Comes with a couple of small zip ties and some double-sided foam tape to attach these to a secure mounting location. So you just want to find a nice spot that's out of the way. It's not going to cause any pinch points or anything. This can get hot, so you want to avoid putting this inside the dust cap or anywhere else that's going to be somewhere that could have any issues with heat. So want to keep it in a nice secure spot somewhere in your engine bay.It does have a little grommet here to plug up the hole going into your light housing.
So you shouldn't have any issues with that. We are going to get the two anti flicker harnesses. So one for either side of our vehicle. It is covered by a limited two year warranty. And this does work with two different light bulbs. It's going to be the Extreme and also the Concept series. So the Extreme is kind of more for an off-road use. It's going to be a brighter, more rugged light. And then the Concept series is more for your everyday road use.So those are both available here at etrailer.com. If you want to get those with this harness, if you don't already have them. If you want to get them together, there is kits that you can get with everything altogether. Sometimes it can be a little bit cheaper to go that route just kind of depends. So not a bad idea to look for that too, right here at etrailer.com. Thanks for watching. And we'll see you on the road.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
Anti-flicker harnesses prevent flickering and "bulb out" dash warnings for H7 LED headlight bulbs. Works with CANbus and PWM equipped vehicles. Plug-and-play installation.
Resistors get the job done for keeping those pesky LEDs under control. Be sure to mount them where the heat they generate don't damage the surrounding material. Mounting to metal is best to conduct the heat away.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.