EcoHitch Stealth Trailer Hitch Installation - 2016 Tesla Model S Video

We can get your 2017 Tesla Model S set up with a trailer hitch receiver for towing your jet ski trailer, and the best option for a hitch that fits your '17 Model S is from EcoHitch: - EcoHitch Stealth Trailer Hitch Receiver #306-X7201 The…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

For the spring eye you would use the Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long #166079, but slipper springs don't have the second spring eye, so a bolt is not used on the back end. You can also use a wet bolt like…

I reached out to my contact at EcoHitch to see if they have seen this issue before with the EcoHitch #306-X7201 on your Tesla and if they have any suggestions. My contact did say that the Tesla rear bumper has quite a bit of tolerance from the…

The Curt Class III trailer hitch for your Pathfinder, part #C13126 would utilize nuts that are welded up into the frame member. The conical toothed washers used in the installation do a good job of maintaining the torque applied to the bolt during…

In most cases Loctite is not required when installing a trailer hitch, but it would not be a bad idea. I suggest using the Loctite Blue Stick Threadlocker, #LT37643, which will provide a secure grip and protect against water and grime.

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

I spoke with one of our contacts at Yakima, who assured me that their HitchSki, part #Y02418 is indeed compatible with the older single-arm SwingDaddy bike rack. For install details and a product demonstration video, click the provided link.

The solution that is the closest to what you mentioned would be the Yakima Hitchski part #Y02418 which is a board carrier that can carry up to 2 boards that is designed to attach to hanging bike racks like the Yakima Ridgeback part #Y02458. There is…

The Eco-Hitch Trailer Hitch Receiver #306-X7201 install will be dependent on your mechanical expertise. It has a difficulty level of 10 out of 10. It requires temporary removal of bumper/fascia during, fascia trimming, it is necessary to drill a hole…

The part we offer as #37185 is actually sold by Hopkins as part #47185 so it's the same exact part. Your truck is prewired for a brake controller installation, but the wiring isn't ran all the way to the bumper. The wiring stops on the…