Speaker 1: Today we're going to be taking a look at hitch locks. We're going to go over the different types and combos available, to help you determine which is going to suit your needs the best.Hitch locks are designed to replace a standard pin and clip. What these allow us to do is secure whatever item that we have in our hitch to the receiver tube opening, so we won't have to worry… see more >
Videos
Help Articles
Expert Answers
No, it does not but there are a couple of options to make them work with a 2-1/2" receiver. The Blue Ox SwayPro Weight Distribution item #BXW1006 and item #BXW1000 are only sold with 2" shanks. The least expensive option is to use…
view full answer...To find out if the Rhino-Rack T-Load Hitch Mounted Load Assist and Support Bar RTL002 will fit beyond the spare tire on your 2010 Toyota FJ Cruiser, there is a simple measurement you can take. Holding a straight edge (like a yardstick) against the…
view full answer...It looks like your dust cap shifted out of place somehow. There is nothing designed to indicate a need for replacement, but that is not the way it should look. I would pull it off all the way and inspect it. If it looks fine drive it back in and…
view full answer...It appears that your u-bolt plate on your 2021 Grand Design Reflection 31MB, will work with the SumoSprings Trailer Helper Springs #SS26MV. The plate itself including the bends does not appear to be larger than 3/4" nor does the width appear to…
view full answer...The #UF48-979002 feature oversized footplates that are 4-1/2" wide by 9" long, so you could use them without leveling blocks. However, it's not uncommon for people to use leveling blocks like #A10-0918 or even wooden blocks under these…
view full answer...We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and a…
view full answer...I do have a solution for you, however the Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers #63080 is specifically designed to work with Draw-Tite 2" x 2" trailer hitch receivers. Because the collars on the hitch…
view full answer...To ensure that your spindle is not sticking out of your hub farther than it should, I would recommend verifying that all of your bearings and seals are seated correctly and the hub is tightened down correctly. When tightening the hub to the spindle,…
view full answer...All of the weight distribution manufacturers have made their shank dimensions to the same standard size which means you can swap brands of shanks without issue. So since you need more drop and have a 2-1/2 inch hitch size the #C17132 would be a…
view full answer...You are correct, you'll just need a WDS shank that is capable of working with your 2017 Ford F-250 with a 2-1/2" x 2-1/2" trailer hitch receiver. I recommend checking out the: -Blue Ox SwayPro Weight Distribution Shank for 2-1/2"…
view full answer...For a weight distribution shank that fits a 2-1/2 inch hitch that has a couple more inches of drop than the #BXW4028 you mentioned you'd want the Equal-i-Zer part #EQ90-02-4900. This shank also fits Blue Ox weight distribution systems like what…
view full answer...For a trailer with a loaded tongue weight of 900 lbs the Blue Ox SwayPro system you'd want is the part #BXW1000 as it has a tongue weight range of between 750 lbs - 1,000 lbs. Your coupler is not underslung too which means the #BXW1000 is a fit.…
view full answer...