etrailer Trailer Jack - Side Frame Mount Jack - TJBB-2001-B Review Video

What you are needing is a hand winch that will ratchet in both directions like the Fulton #F142101. This winch has a gear ratio of 4.1:1. This means to get this drum to turn one revolution you would need to crank this handle around 4.1 times. The…

?The distance from the mounting plate to the foot on the Trailer Valet JX-2K #TV54FR is 13" when fully retracted. The distance from the mounting plate to the top of the jack is 23". This jack can provide you with up to 14" of lift on…

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

For an offset spare tire carrier that would mount to the frame of your Little Guy Rough Rider trailer that would be high enough to give you good ground clearance check out the Offset Trailer Spare Tire Carrier by Dutton-Lainson #DL22120. This carrier…

Whenever available I always recommend going with trailer tires that are rated for higher than 65 mph. It's too easy to accidentally go faster than 65 on the highway even when pulling a trailer so it's always a good idea to have some cushion…

The Pro Series Swivel Jack #PS1400300303 that you referenced should fit fine in your application. In the picture of the jack that I have provided has the measurements indicated. From the center of the mounting bracket to the foot plate is 11 inches.…

The Dutton-Lainson Trailer Coupler part #DL13835 is a direct replacement for the older Dutton-Lainson Trailer Coupler part DL13889. They are not the same but this what you would use if you had the old coupler and needed to replace it. They both have…

Yes, you can remove your weld-on coupler and install a new bolt-on coupler that fits a 2 inch ball. There is just a few things you need to do to before and when installing. You need to know what channel size and the weight capacity you will need for…

There is only one bracket needed to install the Round Snap Ring Swivel Jack part #TJB-2001-Z on your utility trailer and the bracket is included with the jack so no additional purchases are necessary. I have pointed this bracket out for you. It will…

I have attached a dimensional photo of the Curt Single Hook Coiled Safety Cables with S-Hooks part #C80151 and the larger Curt Single Hook Coiled Safety Cables with S-Hooks part #C80176 for you as it would be a bit difficult to explain the dimensions…

There is not a repair kit we carry for Shelby couplers so you will need a new one. Our couplers are designed to fit channel tongues that are a minimum of 2" wide so you would need to use a pair of steel shims for Coupler #CT-2001-Z, which works…

The closest I can come to the measurement you mention is the Pipe Mount Swivel Style Jack, part #DL22685. The center of the mounting pipe to the bottom of the foot plate measures 11-1/2 inches with approximately 3 inches above that. This jack is a…