Redline Trailer Suspension 117594-G Review Video

We sure do. U-Bolt Plate #117594-G is galvanized and attaches a 2 inch square axle to 1-3/4 inch wide leaf springs.

I pulled one of the #117858 U-Bolt plates out of stock and measured the center to center bolt hole spacing for you. From the center of one bolt hole to the next, from side to side, the measuremsnt is 2-5/8 inches. From center to center front to back…

Regardless of the amount of leaves a leaf spring has if the capacity is the same between two of them they would both flex and bottom out the same. I would recommend you have your trailer and boat weighed so that you know whether or not you are…

It really just depends on what you are looking to get out of the bushings. Bronze bushings, like part #K71-291-00, will last longer but are more noisy and it is recommended to use wet bolts like part #126B2 to keep them lubricated. Nylon bushings,…

The most popular trailer wheel bolt pattern is the 5 on 4-1/2 inch bolt pattern and as far as we are aware the bolt pattern you mentioned is not used on trailers at all. So my bet is you probably have the 5 on 4-1/2 inch. I attached a help article…

Installing the U-bolts and plate like that would be fine, but I would recommend putting the plate on the leaf springs and running the U-bolts around the axle instead. The good news is you're replacing them so you can make that change when you…

The closest U-Bolts we have are the following. 1-1/2" x 1/2" x 5" #1753223 1-3/4" x 9/16" x 5" #175130 If neither of these will work for your application you can check your local hardware store.

The Trailer Square U-Bolts part #381344UB is 1-3/4" wide x 4" long x 3/8" diameter. The u-bolts is zinc plated and comes with lock nuts and washers. I have attached a photo showing the above u-bolt in use for you. If you need any other…

The Square U-Bolts #381344UB are 1-3/4" wide on the interior of the 3/8" U-bolt. These are 4" long from the inside of the U to the end of the threads. They can be used in place of the U-Bolts that came with the Malone Crossbar…

Yes, the mounting plate part #116308 that you referenced is a confirmed fit for the U-bolt part #381344UB that you referenced.

The angled portion of the flanges on the part #115983 should run front to back on your trailer and should angle away from your leaf spring. See the attached picture to see exactly how they should install. Typically there are bushings installed in the…

It sounds like you are looking for a u-bolt plate which holds the axle to the leaf spring pack via the u-bolts. If so, you can use the U-Bolt Plate part #TRTP175173 which is designed for 1-3/4" diameter axle with 1-3/4" wide leaf springs.