Review of TRC Enclosed Trailer Parts - 36291-955 Video

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

The closest we have to match those measurements is going to be the H-Channel for Enclosed Trailer #36281-955 which has an internal width of 1.027" and a height of 2". We do also have a C-Channel #362213-955 which has an inside measurement…

The C-Channel for Enclosed Trailer #362213-955 has an opening of 1.027". I have included an image below with all the dimensions for this item.

Generally speaking, the hub face measurements will be around 15" longer than the spring center measurement. That said, this can vary based on multiple different factors such as tire size, offset, etc. The most common options we offer are the…

The Yakima Control Towers like the part #Y8890027 (QTY 1) can fit the Yakima tracks like you mentioned with the Landing Pad 1 part #Y00221. This would work to use the Yakima Round Bars like #Y00409 which is a pair of 58 inch bars.

Your Yakima Landing Pad 1 part #Y00221 is the correct Landing Pad for the Yakima Tracks like the part #Y64MR that you referenced.

With the 1/2 inch diameter wheel studs on your etrailer.com Idler Hub Assemblies #AKIHUB-545-35-K and the 15 inch steel wheels from the Loadstar Tire and Wheel #AM3S640DX, you are looking at a torque spec of 90-120 ft.-lbs for the lug nuts. I have…

The Buyers Products Flatbed/Flatbed Dump Hitch Plate Bumper with 2" Receiver #3371809055 is designed or flatbeds and flatbed dump trucks. While it is ready to mount on Ford trucks, there is some drilling required for GM trucks. This hitch is a…

If you are referring to two white wires from the brake magnet that are coming from the rear of each electric brake assembly, then it would not matter which wire is connected to ground and which wire is used for the brake feed. The magnet that…

The hardware to mount the Tow-Rax L-Track - Tapered - Mill Finish - Aluminum - 24" Long #TWSP24TA you were looking at is not included and we do not currently offer the required hardware. You will need to source it from a local hardware store.…

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

I may have a solution for you, but we don't have any angled trim that is 1-1/2" x 1". The closest available angled trim we currently have available is the Angle Trim for Enclosed Trailer - 93-1/2" Long x 3/4" Tall x…