Customers compare STL211RCB to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Since you trailer's right side turn and tail lights are dim, but still operate somewhat, the most likely cause is a bad ground at the light unit itself. If the main trailer ground were at fault this would affect both sides of the trailer so odds…
view full answer...The easiest way to cut the oval hole for the Rubber Grommet, #a70gb, in my opinion, would be to use a Light Mounting Bracket for 6-1/2 inch Oval Trailer Lights, BK70BB, as a template and then use a hole saw the correct size to cut a hole on each end…
view full answer...EZ Lube axles like the item #T3584F-EZ-8974 come from the factory with just a little bit of grease in the bearings. The first time you use the EZ Lube feature to fill the axle, it will take a lot of grease. You will probably use 3/4 to a full tube…
view full answer...The closest LED tail light we carry to Bargman #30-92-002 that you referenced is part #328-003-81M1 for the passenger's side and #328-003-81LM1 for the driver's side. They're fairly close in size but don't have the reverse light…
view full answer...I have a few options for you to replace the Bargman 30-91-010 Tail Lights. There isn't a direct LED replacement. The Bargman Trailer Tail Light part #30-92-001 and part #30-92-003 are direct replacements but they are incandescent. You could…
view full answer...There are a few options for raising a trailer but they are specific to the axle/suspension setup. The most common of which are leaf spring axles and if this is what you have we have both axle flip kits like the Dexter Trailer Springs Over-Under…
view full answer...There are things that can be done to raise your gooseneck trailer suspension to help provide the proper ride height for your truck. First the capacity of the axles on your trailer should be determined, to be sure that the parts ordered will work…
view full answer...Since LED lights prefer clear lenses for maximum brightness the part #STL211RCB that has the clear lens and red diodes would be brighter than the #STL211RB. If you check out the picture I attached you can see how the diodes of the #STL211RCB are…
view full answer...Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.
view full answer...Typically, if your trailer is exposed to the elements, the breakaway battery should last at least a full season. There are many variables that can affect a batteries life expectancy. The Engager trailer breakaway #20099 includes a built in battery…
view full answer...You do want to charge the battery of the breakaway kit so that in the event you need it the brakes would activate like they need to. That being said that shouldn't affect trailer brakes performance as long as it was install properly. Your best…
view full answer...I would run a set of e-tracks down the length of the floor of your trailer like part #E19148 (5 foot section), and then use the wheel nets like part #EM58523 to secure the wheels of your cars to the tracks. Check out the install videos I attached as…
view full answer...