Customers compare DM12717 to these similar products
Products Featured in this Video
Today we're going to be taking a look at Part Number DM12717. This is the Demco Channel Tongue Trailer Coupler. The straight tongue coupler is made of a sturdy steel construction. It's going to have a corrosion-resistant zinc finish with a 200 hour salt spray rating. It is a bolt-on installation, and it's designed to bolt onto your 3 inch wide trailer tongue. The channel tongue coupler is going to… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The only difference between the Demco Channel Tongue Trailer Coupler part #12564 and Demco Channel Tongue Trailer Coupler part #DM12717 is the bolt pattern which is just slightly different with one having an extra hole.
view full answer...The coupler I recommend for your boat trailer is the Demco Channel Tongue Trailer Coupler #12564, which fits a 3" wide channel tongue, has a 10,000 lb capacity and uses the eZ-Latch system to fit a 2" hitch ball. This will allow you…
view full answer...You can lock out your surge brake actuator although it's not always the prettiest of solutions. You need to either weld the pieces together or drill holes through it putting in bolts to keep it from moving. It'll work but it…
view full answer...I spoke with my contact over at Demco about coupler #12564. From the top (outside) of the coupler above the mounting holes down to the center of the mounting holes measures 1.029". What brand is the coupler you have now because the 1 inch…
view full answer...I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…
view full answer...The HydraStar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness #HS381-9067 is designed to work with an aftermarket electric over hydraulic brake controller. This kit will require you to wire in the components using the wire…
view full answer...While we don't have replacement parts for a Model LP70 actuator, we do have a great replacement solutions for it. Like the 70LP, these actuators are a fit for a 2" hitch ball, but they just have a slightly larger capacity at 7,500 lbs. You…
view full answer...As shown in the provided photo, the approximate distance from the centerline of the trailer ball to the end of the coupler is 12 inches. The Demco #12564 accepts a 2 inch trailer ball.
view full answer...The closest option we have to replace your Atwood 82543 actuator is part #DM72VR. However, it doesn't have the lockout like your Atwood does. To add a lockout use #T4748800 but it's an electric lockout unlike the Atwood's manual lockout.…
view full answer...First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…
view full answer...All of our leaf springs like the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long #e28SR are sold individually. For a single axle you would need two.
view full answer...The HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes part #HS481-8067 has the factory brake controller adapter included so it will work with any integrated factory trailer brake controller like a 2018 Ford F-150 Raptor.
view full answer...