Review of CE Smith Boat Trailer Parts - I-Beam Clamp - CE27682A Video

I do have an option for you but you are correct about the hardware that comes with the CE Smith Roller-Style Guide-Ons for Boat Trailers part #CE27610 not fitting your I-beam that is 5-1/2" tall and 3-1/2" wide. However, you can still use…

The weight capacity listed for a trailer tire is the capacity of just that tire. So for example the Karrier ST225/75R15 Radial Trailer Tire - Load Range E #AM10303 has a maximum load capacity of 2,830 lbs at 80 psi. If you had four of those tires on…

Yes, the CE Smith Bunk-Style Guide-On Kit #CE27600K90 can be used as in interior tunnel guide on for your catamaran boat trailer. The L beams are 19-3/4" long and have no pre drilled holes. The kit will include mounting hardware to attach the…

Technically, you are only limited by the size of the nut and bolt. A longer bolt used would mean you could go to a larger I-beam. With the included hardware the minimum I-beam width is 2-1/2 inches and the maximum is 4-1/2 inches. I made a video…

The CE Smith I-Beam Clamps for Boat Trailers, part #CE27682A are designed for trailer that have an I-Beam 2-1/2 to 4-1/2 inches wide. It seems odd that one side stays on and the other side keeps falling off on your trailer. I do not recommend using…

I don't have a video I can share with you, so the attached photos are the best I can do to hopefully give you an better idea of how the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System - 20' to 28' Long Power Boat #AR84FR work.…

What you are needing is a hand winch that will ratchet in both directions like the Fulton #F142101. This winch has a gear ratio of 4.1:1. This means to get this drum to turn one revolution you would need to crank this handle around 4.1 times. The…

A bushing is not required for the c-hook end (sometimes called an open eye end) of a slipper spring like the 4-Leaf Slipper Spring w/ Open Eye End #e33SR. The closed eye of this spring does have a bushing included; I have added a link to a video…

The axle U-bolt torque spec will depend on the bolt diameter- • 5/16 inch- 65 ft/lbs • 1/2 inch- 45-70 ft/lbs • 9/16 inch- 65-90 ft/lbs • 5/8 inch-100-120 ft/lbs • 3/4 inch-160 ft/lbs Shackle bolts don't typically have a specific torque value.…

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

For bunk style guide-ons such as #CE27600 the bunk board and boat should only barely touch if at all. There isn't a hard and fast rule that says it should be this many inches. But since guide-ons are not meant to support weight like a regular…