Boat Trailer Running Lights Go Out when Stepping on Brake Pedal
Question:
okay I have running lights turn signals brake lights however when I pulled the running lights headlights for at night on and then hit the brakes boat trailer lights go out can you help me?
asked by: Jason
Expert Reply:
This sounds like a ground issue. Ground problems normally show up when there is more draw on a system such as when you have the running lights on and then use another function like a turn signal or brake light.
Make sure that the vehicle side and trailer side connectors are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces.
The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is The Curt C96JR Tail Light Kit Compatible With A Brake Buddy Brake System?
- Q&A: Lighting and Wiring Options for Flat-Towing a Jeep Wrangler Behind a Motor Home
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Q&A: Will The Curt Plug-In Wire Harness For Towed Vehicles Work With A 2020 Jeep Wrangler Unlimited
- Q&A: Best Parts to Flat Tow a Jeep Wrangler TJ with D-Ring Adapters
- Q&A: Does Installing A Wiring Harness On A 2021 Jeep Wrangler JL Require A Wire Run To The Battery?
- Q&A: Correct Tow Bar Wiring For 2022 Jeep Gladiator With LED Lights & ParkSense
- Q&A: Recommended Flat Towing Equipment For A 2003 Jeep Wrangler
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Tow Package for 2011-2013 Jeep Grand Cherokee
- Article: Brake Controller Installation: Starting from Scratch