Fit of Thule Helium Aero 3-Bike Hitch-Mount Carrier # TH9043 on Jeep Liberty

Question

Question:

I have a jeep liberty with a installed hitch. Will Thule Helium Thule Hitching Post Pro fit properly? Or which other?

asked by: Ray S

0

Expert Reply:

The fit of the Thule Hitching Post Pro # TH934XTR on your Jeep Liberty can be determined by taking one simple measurement. The linked article illustrates how to measure from the center of the hitch pin hole to the rear-most part of the vehicle to determine how much clearance you need from a bike rack.

The Thule Hitching Post Pro provides 13-1/2-inches of clearance between the hitch pin hole and the vertical mast. If your vehicle measurement is less than this then the rack will clear the back of your Liberty.

expert reply by: Adam R

0

click to enlarge

Answer 1

The diameter of the larger hole in the adapter part #853-7489 is 1/2 inch.

view full answer...

Answer 2

To choose a compatible rack, you would need to measure the distance between the hitch pin hole in your receiver and the furthest rearward portion of your spare tire, as shown in the photo I edited and the help article I have linked you to. You…

view full answer...

Answer 3

I went to our warehouse to measure Thule Hitching Post Pro #TH934XTR and the height of the vertical arm is 32-1/8 inches long. See the diagram I included. I also measured from the center of the shank to the top of the vertical bar. It measured…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 6

The Global Link RV Entry Door Locking Latch Kit #295-000019 that you referenced would be the correct fit for your 2010 Keystone Montana as this is a fit for standard RV doors like what your Montana has. I attached a review video link for this latch…

view full answer...

Answer 7

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 8

I believe I have a solution for you, but I think you may need to remeasure your cutout and/or compare the measurements of your current latch with one of ours. Since latches tend to be fairly universal in size when it comes to the RV world the Global…

view full answer...

Answer 9

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 10

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 11

We do offer several types of bike carriers designed and rated for use on the front of an RV, including the platform style such as the Swagman Dispatch #S44FR. This carrier features a folding upright mast that allows you access to the vehicle cargo…

view full answer...

Fit of Thule Helium Aero 3-Bike Hitch-Mount Carrier # TH9043 on Jeep Liberty

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching