Propane Regulator Availability for a 1998 Coleman/Fleetwood Santa Fe

Question

Question:

Hello, Im trying to figure out what to purchase to replace my leaking regulators. I have two separate regulators with a Tfoot connector in between for the high pressure outside stove. I cant seem to find this type of setup anywhere so Im wondering if etrailer stocks what I need. Ive included a photo

asked by: Cesar L

0

Expert Reply:

The picture you submitted did not make it through. Without knowing what it looks like its hard for me to say what would work for you. I did attach a link to a page that has all of the regulators we offer for you to check out.

Hopefully one of the ones we carry is the same as what you are looking for.

expert reply by: Jameson C

0

Answer 1

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 2

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the…

view full answer...

Answer 3

For your propane tank with fill valve, you most likely need the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr #CAM59333. This will have the 1/4 inch NPt inlet and the 3/8 NPT outlet and will maintain a constant 11 inch water…

view full answer...

Answer 4

The regulator I recommend to connect your 100 lb propane tank to your tankless water heater and range/stove is the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr #CAM59333. I recommend this Camco because it is rated for…

view full answer...

Answer 5

Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…

view full answer...

Answer 6

The Dexter part number 023-357-00 is a 12x2 electric brake assembly. The correct RH assembly to use to replace what you have would be the part #23-459 and for the LH assembly you would want the part #23-458 if you have 6K axles. If you have 7k…

view full answer...

Answer 7

The fan in the #PD4645V is temperature controlled so typically it does not run continuously. However, if there are heavy loads you can expect the fan to run non-stop. According to Progressive Dynamics, this can also happen if you're…

view full answer...

Answer 8

The Marshall 290 model regulator is a standard vertical 2-stage regulator, unlike the horizontal Marshall 260 and Camco #CAM59333 that you mentioned. This means to replace your Marshal 290 you will want the Camco Vertical 2-Stage Regulator…

view full answer...

Answer 9

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down…

view full answer...

Answer 10

The Dexter Electric Trailer Brake Kit #23-105-106 are a replacement set for the 023-358-00. This kit includes a right and left brake assembly that is manually adjustable. I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as…

view full answer...