Length Of The U-Bolts In The Replacement U-Bolt Axle Mounting Hardware Kit # LC27XV

Question

Question:

what is the length of the U-bolt please

asked by: Rob C

0

Expert Reply:

Hey Rob,

The Replacement U-Bolt Axle Mounting Hardware Kit # LC27XV comes with U-bolts that are 7" in total length, 5" of length from the threads to the start of the bend, and 1-7/8" thread length.

expert reply by: Kevin C

0

LC27XV Length
(click to enlarge)

Answer 1

In order to measure for a new set of trailer leaf springs you'll need to jack the trailer up and let the axles hang freely, then you can measure the unloaded length eye to eye. Once you get the correct length you can obtain the axle capacity…

view full answer...

Answer 2

It does appear that the leaf springs on your 2003 Keystone Springdale Travel Trailer are worn and need replaced. In order to find the correct replacement leaf springs you first need to start by noting the type whether that be slipper or double eye.…

view full answer...

Answer 3

Good question, and what happens is that leaf springs elongate over time, and since you mentioned you got measurements of 25-1/2 inches from center eye to center eye and 26 inches under partial load, the best option for leaf springs really is the…

view full answer...

Answer 4

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 8

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 9

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 12

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Length Of The U-Bolts In The Replacement U-Bolt Axle Mounting Hardware Kit # LC27XV

Product Page this Question was Asked From

Continue Researching