Can Support Bar That Runs in Bracket Track on Lippert Manual Pull-Out Step Be Removed
Question:
I cant tell from any of the photos – can the step detach from the mounting bracket that holds the assembly to the trailer? I cant tell if there is a cotter pin holding the bar in place which would allow for easy detachment of step from mounting bracket or if there are washers or something welded to the end of the rod/crossbar. Talking about the rod/bar that rides in the slot to pull the steps out or put them away. Thanks.
asked by: CG
Expert Reply:
Yes, that is a cotter pin and washer that can be removed. This would allow you to pull the bar out of that track and remove the # LC432682 steps from the bracket if need be.
Product Page this Question was Asked From
Lippert Manual Pull-Out Step for RVs - Double - 7" Drop - 24-1/4" Wide - Steel - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 25-1/2 Inch Wide
- 2 Steps
- 7 Inch Drop/Rise
- No Ground Contact
- Steel
- Lippert
more information >
Continue Researching
- Q&A: Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks
- Q&A: Dimensions for the 10K Demco eZ-Latch A-Frame Trailer Coupler
- Q&A: Can ARK Stabilizer Jacks Rotate 180 Degrees
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Recommended Replacement Stabilizer Jacks For A 2011 K-Z Durango 1500
- Q&A: Dimensions of Weld-On Plate for Ark Drop Down Corner RV Stabilizer Jack Kit
- Q&A: Overall Length of the 24" and 30" Ark Drop Down Corner Stabilizer Jacks
- Q&A: Recommended A-Frame Trailer Jacks That Are Compatible W/ Demco A-Frame Coupler DM14793-95
- Article: How to Measure for Motorhome Steps
- Article: Trailer Wiring Diagrams
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Measure for Trailer Hitch Drop
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)