Finding Stoplight Circuit for Brake Controller Install Ford Dump Truck
Question:
I am wiring up the ETBC7 in conjunction with Tekonsha Voyager brake controller. This is on my 1988 Ford F600 dump truck, gas engine 370-2v. The problem I ran into is tapping into the brake light switch. I don’t think I am able to after reading up on it. I’m pretty sure the brakes and turn signals are on the same switch. And I can’t tap into that because the brake controller may activate when using the turn signals. There is no visible third brake light on this either because it’s a dump truck and the original chassis cab didn’t have one. What do I do? Thanks.
asked by: Franco
Expert Reply:
Hey Franco, we have an easy solution to provide a stoplight circuit on your dump truck with the Roadmaster Universal Stop Light Switch Kit # RM-751000. Some vehicles have a hard time finding the stoplight circuit but this switch solves the problem.
Products Referenced in This Question
Roadmaster Universal Stop Light Switch Kit
- Tow Bar Braking Systems
- Stop Light Switch
- Roadmaster
more information >
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Q&A: Tool for Adjusting Drum Brakes on Drop Axle
- Q&A: Does a 2022 Chevrolet Silverado 3500 Short Bed Need a Sliding 5th Wheel Hitch
- Q&A: Picking Between ETBC7 and ETBC7L for Brake Controller Install
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
Franco
3/14/2024
Thanks Jameson. So, I just install this universal Stop light switch kit and then tap into the wire on it from my brake controller harness? Any better install videos on this road master kit? Thanks.