Which Brake Switch Wire is the Right One on a 2008 Chevy Express Van to Install a Brake Controller
Question:
Hi, I purchased your universal kit ETBC7 for a the trailer brake controller. I have a question about the brake light switch. I watched your video for the closest vehicle I own 2003 Express van but the connector is different on my 08, and Im getting something a bit weird. When I use the test light on the connector, I get one that stays lit all the time, one that stays lit but when the brake pedal is depressed, it goes out, and two more that show no power at all. Kinda confused, I thought you are supposed to have one that comes on when the brake pedal is depressed...Can you folks shed a little light on how to connect this thing up?
asked by: Shelley R
Expert Reply:
On a 2008 Chevy Express Van the wire on the brake switch you need should be a white wire but it could also be a light blue wire with a white strip. That is the correct wire from the cold side of the brake switch. The vehicle key will have to be on for it so show power with the brake pedal.
If you cannot locate the wire then make sure the stop light or CHMSL fuse is not blown. Use the owners manual to find the locations of fuses. If you cannot get a dedicated brake light only signal from the brake switch then you could use a fuse tap and get it from the CHMSL fuse provided the fuse does not power any other functions, such as hazards.
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Video: Review of etrailer - Brake Controller - ETBC7
- Video: Review of Tow Ready No Drill Mount Bracket - 18136
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Deka Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 1
- Shop: Mighty Cord Universal 7-Way Mounting Bracket
- Shop: Ring Terminal - 12-10 Gauge Wire - 3/16" Ring ID
- Shop: No-Drill Mount Bracket, Long
- Shop: Extension Cable for Hopkins Smart Hitch Backup Camera - 5 ft
- Shop: 12 Gauge Black Primary Wire - per foot
- Search Results: bracket for 7 way
- Search Results: 44~5310a
- Search Results: adapter
- Search Results: back up camera
- Search Results: dw05745
- Search Results: no drill mount bracket
- Search Results: hm50002
- Shop: Brake Controller
- Shop: Trailer Wiring
- Q&A: Do Proportional Brake Controller Require Tapping into Stoplight Circuit of Brake Pedal Switch
- Q&A: Does a Brake Controller Red Wire Have to Attach to the Brake Switch on a Vehicle
- Q&A: How to Find the Brake Switch Stop Light Wire on a 2006 Nissan Pathfinder
- Q&A: Obtaining Brake Stop Light Signal to Install Brake Controller in 2003 Subaru Forester
- Q&A: Brake Switch Wire Location to Hardwire a Trailer Brake Controller on a 1997 Chevy Suburban
- Q&A: 2 Brake Switch Wires have Power with Brake Pedal on a 2016 Ford Escape
- Q&A: Locating Brake Stop Lamp Switch to Install Brake Controller on 2012 Chevy Colorado
- Shop: Vehicle Tow Bar Brake System
- Video: Roadmaster Universal Stop Light Switch Kit Instalaltion - 2021 Chevrolet Trailblazer
- Video: Trailer Wiring Harness Installation - 2009 Chevrolet Express Van
- Video: Trailer Brake Controller Installation - 2003 Chevrolet Express Van 90185
- Video: Trailer Brake Controller Installation Wiring Kit Review