Replacement Fulton Jack for a Ranger Boat Trailer
Question:
Is this a replacement Fulton jack presently on a ranger boat they look the same?
asked by: Pete B
Helpful Expert Reply:
It is possible that Fulton jack # FTJ120W0301 is the same jack that is used on your Ranger boat trailer. If your current jack is a side wind swivel jack with 10 inches of lift and rated for 1,200 pounds AND it mounts to a bracket welded to the trailer frame and held to it with a snap ring, then yes, this is the correct jack. I have linked a video review of this jack for you.
I have also included a link to all of the Fulton side winding swivel jacks for you.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Best Boat Trailer Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Article: Trailer Lighting Requirements
- Article: Trailer Jacks
- Q&A: Dimensions of Weld-On Plate for Ark Drop Down Corner RV Stabilizer Jack Kit
- Q&A: Measurements Of The Ark Drop Down Jack When Folded Into Stored Position And Retracted position
- Q&A: Recommended Replacement Stabilizer Jacks For A 2011 K-Z Durango 1500
- Q&A: Jack Recommendation for a Triton Boat Trailer