Will etrailer Enclosed Trailer Transition Plate Work For Horse Trailer

Question

Question:

I would love to get this for my horse trailer. I have a large equipment trunk that I take to competitions and it getting it over the gaps is difficult. However, I would need to be able to either walk my horse over it or remove it to allow my horse to walk over it. Would this be doable?

asked by: Valerie P

0

Expert Reply:

You can definitely use the etrailer Enclosed Trailer Transition Plate # e32JR on your horse trailer. Uninstalling and reinstalling the plate will not be necessary and isn't recommended. The plate is only 15" long so your horse could step right over it without any issues. The plate can also handle 1,000 lbs, so unless the horse put all if its weight on the plate it should be able to handle it if stepped on. Alternatively, you can flip it up into the stowed position and it will be like the plate isn't even there.

expert reply by: Robin H

0

Answer 1

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 2

I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured also.…

view full answer...

Answer 3

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

view full answer...

Answer 4

I looked up pictures of the taillights that are on the 3110 Featherlite trailers and for the LED version of them you would want the part #STL36RB and #STL37RB. It looks like the spare tire mounts for your trailer are something you would have to get…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

view full answer...

Answer 7

The 22 mm size that is mentioned for the Wheelmaster lug nut part #WM9062 that you referenced is the size of the thread.

view full answer...

Answer 8

There is a trailer wiring harness for the 2020 Ford Edge Titanium with Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #C73FR which will plug in behind the tail lights and give you a 4-pole flat on the Edge to power…

view full answer...

Answer 9

You can use the Go Power #34264403 Automatic Transfer Switch for 30 amp service. This transfer switch automatically changes from inverter to shore power when you hook up at the campground. It also protects your electrical system from AC power…

view full answer...

Answer 10

I have a solution for you, however, the jack that you referenced will not fit a 5 inch trailer tongue. The Fulton Bolt-Thru Swivel Marine Jack, #FXP15, will fit 3 inch x 5 inch trailer tongue and has a lift capacity of 1,500 lbs. This Fulton jack is…

view full answer...

Answer 11

According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…

view full answer...

Answer 12

The replacement reverse lock out you are looking for is the part #TK71-755-00. This would allow you to use the same adapters and fittings you have now.

view full answer...

Will etrailer Enclosed Trailer Transition Plate Work For Horse Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching