Would the Curt Chain Hanger part # C17003 fit 3 Inch Channel Trailer Frame
Question:
My small Casita trailer has the front frame constructed of 3inch channel, with the flat side inside. Will this product, which would be about 1/2inch wider than the frame, work? The trailer is only about 1200 lbs, but I am trying to keep the car-trailer level, plus my hitch Ford Flex is quite low, hence the weight distributing hitch.
asked by: Bob H
Expert Reply:
Actually the inside width of the frame channels of the Curt Hangers part # C17003 that you referenced is 3-3/16 inches so it would only be a little bit wider than the 3 inch channel of your trailer frame. And even if your trailer was half an inch narrower than the hanger this kit comes with pretty long set screws to take up that distance. So to answer your question, yes this kit will work for you.
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow, this figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached an FAQ on determining tongue weight for you to check out as well.
Product Page this Question was Asked From
Chain Hangers for Curt Weight Distribution Systems - Clamp On
- Accessories and Parts
- Weight Distribution Hitch
- Chain Hangers
- CURT
more information >
Continue Researching
- Shop: Chain Hangers for Curt Weight Distribution Systems - Clamp On
- Shop: Curt MV Weight Distribution System w/ Friction Sway Control - Round Bar - 14K GTW, 1.4K TW
- Search Results: curt weight distribution hitch
- Shop: Chain Hangers for Curt Weight Distribution Systems - Bolt On
- Q&A: Does the Trailer Need to Be Jacked Up to Install Chains on Chain Hangers # C17003
- Q&A: Bolt Sizes and Bracket Dimensions of Chain Hangers for Curt Weight Distribution Systems
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Shop: Replacement Lift Bracket for Curt Weight Distribution Systems
- Shop: Trailer Wiring
- Shop: Curt MV Weight Distribution System - Round Bar - 10,000 lbs GTW, 1,000 lbs TW
- Shop: Curt Trunnion Style Weight Distribution System with Shank, 1,000 lbs. TW, 10,000 lbs. GTW
- Shop: Brake Controller
- Search Results: curt wdh
- Search Results: load bar
- Q&A: Do Alternate Chain Lift Brackets C17003 Change Setup of Weight Distribution Hitch
- Q&A: Placement and Orientation of Tekonsha P3 Brake Controller
- Q&A: Can Curt Chain Hanger Brackets be Used with a Pro Series Weight Distribution System
- Video: Review of Curt Weight Distribution Hitch - WD Only - 17302
- Video: Review of CURT Weight Distribution Hitch - MV 14K W.D. with Sway Control - C17063
- Q&A: Does Using A Weight Distribution System Add Stress To the Vehicle Frame
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: 5 Things to Know About Weight Distribution Hitches
- Shop: Vehicle Tow Bar Brake System
- Shop: Roof Rack
- Shop: Suspension Enhancement
- Shop: Trailer Hitch
- Shop: Vehicle Engine Heaters
- Q&A: Wiring Connection For Passenger Side Curt Vehicle Wiring Harness on 2019 Chevrolet Express 3500 Van
- Video: Review of CURT Weight Distribution Hitch - MV 10K Weight Distribution System - C17052
- Video: LubriMatic Electrical Connector Dielectric Grease Review