Can Inno Gravity Ski Carrier be Separated into Two Smaller Carriers

Question

Question:

Can this carrier be separared? I want to use half when using my cargo box and when no cargo box use the full size. If yes do I need to purchased separate clamps or can the be removed from the one side of the large carrier and moved to make it a small carrier?

asked by: Jason B

0

Expert Reply:

The Inno Gravity Ski Carrier part # INA951 that you referenced was not designed to separate into two smaller racks and it can only be used as a complete unit. For a smaller version of this you would want the part # INA952.

expert reply by: Jameson C

0

Answer 1

Your 2008 Jeep Grand Cherokee should already be equipped with the rails along the edges of the roof that run from front to back. Rhino Rack offers a strong, aerodynamic crossbar set-up for your vehicle that's also reasonably priced. The rack…

view full answer...

Answer 2

Since you said 71 inch crossbars wouldn't extend past the side mirrors on your 2022 Lexus GX460 it would work and be safe. You'd want to watch your head getting and and out of the vehicle and also around tight corners in like drive through…

view full answer...

Answer 3

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 4

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 5

You certainly can install two pairs of the Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR on your trailer. In that case we recommend adding one jack to each corner of the trailer frame. Keep in mind that these are designed to stabilize, not lift…

view full answer...

Answer 6

The Inno Ski and Snowboard Roof Rack - Dual Angle - Locking #INTX726 just needs roof rails or fixed mounting points to attach and from what I could find, it looks like your vehicle came equipped with factory flush rails so this should work fine,…

view full answer...

Answer 7

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 8

Yes, the Thule SnowPack Ski & Snowboard Carrier #TH7326 is compatible with the roof rack crossbars from Rhino Rack that you referenced and would be a great choice for your son. The parts you need to add that Rhino Rack on his 2014 Chevy Equinox…

view full answer...

Answer 9

I have the correct size for you! Since the front crossbar of the Rhino-Rack ROC25 #RR78TR measures 40-9/16" long, the 50" Fairing #RRRF4 is too long for the setup. The clamps of the 50" will interfere with the feet on the rack. With…

view full answer...

Answer 10

Due to the length of the Buyers Products 18 " Hitch Receiver Extension with Step #3371804017 that you referenced there isn't a way to use it with a ball mount without cutting the capacity by 1/3 like you mentioned.

view full answer...

Answer 11

You are correct, using the 30% capacity reduction of the Buyers Products Hitch Extension #3371804017, the capacity of your Torklift hitch, and the weight of your trailer you would easily have the capacity to tow your trailer!

view full answer...

Can Inno Gravity Ski Carrier be Separated into Two Smaller Carriers

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching