Recommended Replacement Red Clearance Light With 3" Mounting Hole Spacing

Question

Question:

Hi. We are looking to replace a red clearance side marker light on our horse trailer. Is is 3 from screw to screw. Can you help me find one.

asked by: Kim M

0

Expert Reply:

The LED Clearance or Side Marker Trailer Light w/ Reflector # MCL0032RBB has a 3" spacing from mounting hole to mounting hole. Its overall dimensions are 4" long x 2" tall x 1" thick. You'll want to use some sealant around the outer edge of the light once installed to prevent any water from getting behind it and into the wall of the trailer.

expert reply by: Kevin C

0

Answer 1

While we do not carry the lens for your Arrow 071 clearance light we do have a Thinline LED Trailer Clearance #MCL67RB which is 4-1/8" long and 1-1/4" wide. It has mounting holes 3" on center like your current clearance lights. You…

view full answer...

Answer 2

The 1-7/8 inch width is what is rounded up to 2 inches which is a standard width for winch straps. The 14 foot length is not something we carry. I recommend the Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs #DL24239 or…

view full answer...

Answer 3

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 4

The #37213635 JR Products Replacement Landing Gear Switch you'd mentioned would be a proper replacement for your existing Atwood 70254 landing gear switch. If you wanted the switch, wiring harness and the bezel for the switch, use the Stromberg…

view full answer...

Answer 5

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 6

The 4-Pole, Round Pin Trailer Wiring Connector #PK11402 is a standard size used in North America. Do understand that while there is a standard wiring pattern it is possible to be wired differently which could cause issues.

view full answer...

Answer 7

We may have some potential options for replacing the tack room door lock on your Featherlight trailer. Is the 5" L x 5" H dimension you gave for the door cutout or the lock itself? The best way to find the right replacement lock is to go by…

view full answer...

Answer 8

I believe that the Curt T-Connector that is installed on your 2015 Toyota Highlander is part #C56217. Since it comes with a 10amp fuse you will want to make sure that you continue to use a 10amp fuse because the fuse relates directly to this wiring…

view full answer...

Recommended Replacement Red Clearance Light With 3" Mounting Hole Spacing

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching