Replacement L-Bracket for Reese Weight Distribution System 49913  

The Reese Weight Distribution Systems like part #RE44FR will allow you to reverse without having to disengage the spring bars. That said, you need to make sure you are doing so at a relatively straight angle meaning you can't put the trailer…

Since you mentioned that you're only experiencing a little bit of sag on your truck with your Reese Pro Round Bar Weight Distribution w Sway Control #RE44FR, I recommend adding another washer. Reason being, installing each washer will lower…

The Reese #RE44FR would indeed offer weight distribution and sway control. The kit includes a 2-5/16 inch trailer ball and the adjustable weight distribution shank. The system is rated for trailers with a 600-1150 lb fully loaded tongue weight. You…

If you are still getting significant sway with your setup the solution wouldn't actually be a different weight distribution system. What you are in need of most likely is actually most likely getting more weight forward in the trailer so that…

The Reese Pro Round Bar Weight Distribution w Sway Control #RE44FR is rated for a tongue weight of 600-1,150lbs and a maximum trailer weight of 11,500lbs. With your trailer GVWR being 9465 and dry tongue weight of 650lbs you do meet all the…

Yes, you can flip the shank in the weight distribution system #RE44FR upside down in order to get more of a rise. In this position the maximum rise is 8-1/2 inches measured from the top of the hitch receiver opening to the top of the ball platform…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…