Replacement Touch Screen for 2018 Columbus Palomino FK 385

Question

Question:

I have a 2018 Columbus palomino FK 385. I don’t know which touch screen would work for my rv replacement panel.

asked by: Michelle R

1

Helpful Expert Reply:

Thank you for the pictures of your current touch screen. Based on seeing them the correct replacement is the part # LC83VR that you referenced.

expert reply by: Jameson C

1

Touchscreen Panel
(click to enlarge)

Panel RV
(click to enlarge)

Answer 1

Thank you for providing those pictures, using the pictures I was able to determine that the Replacement Touch Screen Control Panel #LC83VR is the correct replacement for your Lippert jack system.

view full answer...

Answer 2

Thank you so much for the photos! They were super helpful, and I can verify for you that the correct touch screen panel for your Lippert 6-point leveling system is the part number you asked about: - Replacement Touch Screen Control Panel #LC83VR…

view full answer...

Answer 3

The 5 inch and 7 inch screens are interchangeable. If you want a 5 inch screen you'd want the part #LC83VR or if you want a 7 inch screen part #LC75UD.

view full answer...

Answer 4

If you are receiving power to your screen and have confirmed all of your connections are good then it sounds like you will need to replace it. One last thing you can try is to completely power off your Onecontrol system in hopes of resetting it but…

view full answer...

Answer 5

The Replacement Touch Screen Control Panel #LC83VR currently (December 2023) ships with the software OCTP V4.2. To check which version is installed on the screen you can look at the bottom right corner of the page, or by going to Settings and under…

view full answer...

Answer 6

I reached out to Lippert and the fuse configuration pin you need to program your Replacement Touchscreen Remote w/ Charger for Lippert Ground Control 3.0 Electric Leveling System #LC358601 is 1956. I have attached the operation and programming…

view full answer...

Answer 7

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the…

view full answer...

Answer 8

I recommend replacing an entire ladder if it's damaged. You'll want to find a replacement based on the height. Such as the Stromberg Carlson #LA-401 that is 99-1/2 inches tall. They can be cut shorter to customize the length if…

view full answer...

Answer 9

While trailer axles do feature an upward bend like you are describing, there isn't a particular amount/measurement that is standard across the board. This bend in the axle is designed so that it will straighten under a trailer's…

view full answer...

Answer 10

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5…

view full answer...

Replacement Touch Screen for 2018 Columbus Palomino FK 385

Product Page this Question was Asked From

Continue Researching