Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710

Question

Question:

We have a 2016 Newmar canyon star 3710. It has the equalizer leveling system. The jack feet are octagon shape. They measure 10inch from end to end on outside. Inside round hole is 8 3/4 to 9. Which model number pad do I need. Thank you

asked by: James H

1

Helpful Expert Reply:

For 10" octagon shaped jack feet you would need the SnapPad EQ Octagon Jack Pads # SN76FR that you were already looking at, but before purchasing you'll need to measure just how tall the edges stick up from the ground since your jack feet curl up. The pads that we offer only have a gap large enough to handle 1/4". If the edges raise higher than 1/4" then you wouldn't be able to use SnapPads and would need to use the Stromberg Carlson RV Jack Pads for Equalizer Systems - 10" Round or Octagonal Jack Feet # SC56MR instead.

expert reply by: Kevin C

1

Jack Foot 1
(click to enlarge)

Jack Foot 2
(click to enlarge)

Answer 1

Sure thing! For your 2020 Chevrolet Sonic Hatchback, you're going to need: -A base plate kit, Blue Ox Base Plate Kit #BX1703, -A tow bar, the Curt Rambler Steel Tow Bar for Curt and Blue Ox Base Plates #C26FR, -A wiring kit, Roadmaster Tail…

view full answer...

Answer 2

Yes, the SnapPad EQ Octagon Jack Pads for Equalizer Leveling System w 10" Octagon Jack Feet #SN76FR reshape back to the original shape after they are used on uneven surfaces. The SnapPad EQ Ocotagon Jack Pads #SN76FR will work on any type…

view full answer...

Answer 3

Hello John. The #C96JR tail light kit for the 2023 Jeep Gladiator will indeed work with a Brake Buddy brake System Such as part #HM39524. So, if you plan to use a portable brake system, that is definitely what I recommend, and you do not need to…

view full answer...

Answer 4

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck…

view full answer...

Answer 5

The SnapPad Prime Jack Pads #SP84FR4 are specifically designed to fit the Power Gear Leveling Systems w/ 10" Round Concave Jack Feet on your 2014 Fleetwood Bounder 34B. The Pads #SC99MR Stromberg told you to use will not fit on your Bounder as…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hey Brad, thanks a bunch for going ahead and getting all those measurements in advance. Based on the measurements you've given, the TorkLift GlowStep Revolution Uprising Steps w/ Booster Step #TL52SR will work perfect for your coach. These steps…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally your jacks will have the…

view full answer...

Answer 10

Hey Lisa, To flat tow your 2020 Jeep Grand Cherokee Trailhawk you'll need the Blue Ox Tow Bar Wiring Kit #BLU86XR. This wiring harness comes with connectors to plug inline with your factory tail light wiring. If you haven't picked out the…

view full answer...

Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching