Wiring Brake Controller and 7-Way to 2013 Lincoln MKT
Question:
How to install a 7way harness on a 2013 Lincoln MTK without a towing package.All fuses and relays r factory provided for such wiring at power distribution center.Harness is provided for brake controller at knee bolster location.Thank you ,
asked by: Kent
Expert Reply:
We have a way to install a 7-way on your 2013 Lincoln MKT but there isn't a way to tie into any factory wiring. What you'd need to start with a custom fit 4-way part # C56095 and then convert that to a 7-way with the part # ETBC7 which also comes with everything needed to wire up a brake controller as well.
Then for a brake controller the P2 # 90885 would work really well. If you can verify the brake controller wiring is active you can use some of the circuits there. Red wire of controller would run to wire that has brake light circuit, white to ground, black to 12 volt positive circuit and you'd be set.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch for 2013 Ford Flex Limited with Dual Exhaust
- Q&A: Which Curt Hitch 2016 Ford Flex with Dual Exhaust
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Determining Trailer Tongue Weight
- Q&A: How Heavy of a Trailer Can 2011 Lincoln MKT Tow with etrailer Hitch e52AR Installed
- Q&A: Choosing Correct Hitch Tongue Weight Capacity for Using a 4-Bike Platform Bike Rack on Honda CR-V
- Q&A: 2016 Cadillac SRX Electric Brake Controller Installation
- Article: Frequently Asked Questions About Transmission Coolers
- Article: Performance Chips and Modules
- Article: Rooftop Cargo Carriers
- Article: My Trailer Hitch Doesn't Fit