RV Roof Vent that can Be Use 120 AC Power

Question

Question:

I have a vent that is wired for an a/c and the wires are 20 amp and 125 volt. The current vent has nothing mounted in it. I am looking at putting in the Maxxfan 7500k to have air movement in the area. Can I wire the new fan into the existing power supply??

asked by: Chuck T

0

Expert Reply:

We do have one RV roof vent that can be used with 120 volt power with the Ventline Roof Vent part # V2128SP-01. This would work great with the AC power you have currently there. We don't have any MaxxFans that can be used with this type of power source.

expert reply by: Jameson C

0

Answer 1

You are correct; the Ventline Roof Vent w/ 110V Fan #V2128SP-01 does run on 110 volt AC power. This vent comes with a garnish and fits roofs 2-1/8" to 3-1/4" thick. I have added a link to a video review of this vent for you to take a look…

view full answer...

Answer 2

Because the Ventline fan #V2128SP-01 is 110 volt, it would have to run off of AC power (110 volt shore power). This item is normally found on larger motor homes and will run when connected to shore power or when using a generator. Because the motor…

view full answer...

Answer 3

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 6

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 7

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 8

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 9

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 10

Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.

view full answer...

Answer 11

The Replacement Crank Extension for Lippert Components Spare Tire Winch Assemblies #LC1315411, which is a replacement for Lippert Components Spare Tire Winch with Offset Cable #LC159056, has an inside diameter of 0.50 inches and the hex has a 0.75…

view full answer...

Answer 12

There are going to be two parts to the handle that you will need to operate the Lippert Components Spare Tire Winch part #LC159056. The first of which is the intermediate shaft or what Lippert calls a Crank Extension part #LC1315411. This will be…

view full answer...

RV Roof Vent that can Be Use 120 AC Power

Product Page this Question was Asked From

Continue Researching