Trailer Hitch Receiver and Wiring for 1990 Toyota Land Cruiser
Question:
I have a 1990 Land Cruiser I need to install a class III hitch too and a 4 pin wire system for the land crusier. This is an imported from Japanese HDJ81R. What do you have that could work?
asked by: Nate
Expert Reply:
I do have a solution, but there are no custom fit hitches for a 1990 Toyota Land Cruiser. What you can use is a universal hitch like the Draw-Tite # 41990-07. This is a weld-on hitch so you will need to take it to a certified welder for installation. I know you asked for a Class III but it won't hurt to have the higher hitch capacity since you will be limited by your vehicle capacity.
You will also need a universal wiring kit for the 4-way. The Curt # C59236 comes with everything you need to install a 4-way on your Land Cruiser. You can mount the 4-way on your hitch using the # C42CR along with the # 18140 for a no-drill installation.
Products Referenced in This Question
No-Drill Mount for Electrical Mounting Bracket - Short
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Flat
- 5 Flat
- 4 Round
- 5 Round
- Tow Ready
more information >
Curt Mounting Bracket for 4-Pole Flat Trailer Connector
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Flat
- CURT
more information >
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"
- Heavy Duty Receiver Hitch
- Weld-On
- 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- 7 Inch Drop
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch Recommendation for an International 4300
- Q&A: Hitch Recommendation for a Ford E-450 Bus
- Q&A: Recommended Class V Hitch For A 2020 Ford F53 Chassis
- Q&A: Universal Hitch to Install on a Class A RV Rated for 10,000 Pounds
- Q&A: Trailer Hitch for 2010 IC Bus CE-Series
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch For 2014 GMC Savana Cutaway Chassis
- Article: What is Boondocking
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop