Replacement Fan Blade for Advent Air RV Air Conditioner ACM150SP

Question

Question:

Will this fit Advent a/c ACM150SP?

asked by: Lydia

0

Expert Reply:

Yes, the Replacement Fan Blade for Advent Air RV Air Conditioner item # PXX128050095 will fit the Advent A/C ACM150SP.

expert reply by: Jerred H

0

Answer 1

ASA Electronics couldn't say if their #PXX128050095 replacement fan would work on a Carrier AC unit. I can provide you with the measurements you had asked for, though. The fan would indeed be compatible with a 1/2 inch shaft that has a flat…

view full answer...

Answer 2

Yes, the Replacement Fan Blade for Advent Air RV Air Conditioner part #PXX128050095 will fit a Advent Air RV Air Conditioner part AC135/ACM135 as it's the same unit.

view full answer...

Answer 3

That Advent Air replacement fan blade is no longer available but we do have the part #PXX128050095 which is the current fan blade replacement for Advent Air AC units and would be what you would need.

view full answer...

Answer 4

Based off your description I believe you're talking about the "Blower Wheel" which can be replaced with part #ADV49FR. The fan blade on your Advent Air RV Air Conditioner #ACM150 can be replaced with the Replacement Fan…

view full answer...

Answer 5

In order to find the correct replacement fan blade for your 2012 Forest River Cherokee, I am going to need to know what you have in your trailer currently. For instance, if you had the Advent Air RV Air Conditioner #ACM135, then you could use the:…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you,…

view full answer...

Replacement Fan Blade for Advent Air RV Air Conditioner ACM150SP

Product Page this Question was Asked From

Continue Researching