Availability of Aftermarket Puck System for 2023 GMC Sierra 2500

Question

Question:

My 2023 GMC Sierra 2500 Duramax HD Denali did not come with a pick system. Can I purchase the truck mount puck system for my truck?

asked by: Bob

0

Expert Reply:

At this time, the Curt # C16429-204 above bed rails are the only confirmed fit for the 2023 GMC Sierra 2500. This would allow you to use a 5th wheel hitch like the # C16541 if you have a short bed or # C16140 for a long bed.

For an underbed system, it may be possible to use the B&W Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRK1020. However, B&W only has reports of some customers and dealers successfully installing the hitch so we cannot guarantee it will fit.

This would allow you to use a Companion like the # BWRVK3400 or # BWRVK3500 and give you full bed access when you aren't towing. If you go this route, B&W recommends dry fitting before cutting any holes in your truck bed.

expert reply by: Robin H

0

Answer 1

When you install the Curt Custom Fifth Wheel Installation Kit for Chevy/GMC Truck - Carbide Finish part #C16429-204 in the 2020 Chevy 2500Hd short bed, the measurement from the tailgate to the rails is 28.94" like you mention because you want…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 4

On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

I attached a link to this page that has the install instructions for the Axle Riser Kit #LC382741 that you referenced.

view full answer...

Answer 7

According to Lippert, the mounting nuts should be torqued to 120 ft-lbs for the Axle Riser Kit - Single Square Torsion Axle - 3-1/2" Lift #LC382741.

view full answer...

Answer 8

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 9

I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS would easily fit in place of it and would also work really…

view full answer...

Answer 10

To convert a Curt A16 fifth wheel hitch to fit the OEM pucks of your 2022 Ford F-250 the leg kit you'd want is actually the part #C16017. This would essentially give you the #C16520-16017 which is the Curt A16 that fits directly to you pucks.

view full answer...

Availability of Aftermarket Puck System for 2023 GMC Sierra 2500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching