Is Box Needed To Install SmartPlug RV Power Inlet?

Question

Question:

do you offer a surface box to mount the smart plug 50 amp in

asked by: Michael T

0

Expert Reply:

All of the SmartPlug RV Power Inlets such as the # SM56FR you were looking at attach directly to the exterior wall of your RV, and there is no box compatible with them.

I included a video of this plug being installed for you to take a look at.

expert reply by: Samuel C

0

Answer 1

12 KW converted to amps at 125 volts is 55 amps and the Mighty Cord part #A10-5025EDBK is only rated for 50 amps. So while your generator can put out more amperage than needed it would come down to whether or not your entire house would draw more…

view full answer...

Answer 2

If you're only wanting to setup AC service in your enclosed trailer then you could choose pretty much any 30 or 50 amp power inlet you wanted and then just run the appropriate gauge wire between the inlet and your panel. You can definitely…

view full answer...

Answer 3

Yes, the male side of the Mighty Cord RV Power Cord #A10-5025EDBK is a Nema 14-50 connector.

view full answer...

Answer 4

I double checked with the manufacturer and you were correct in your assumption. On the 50 amp hardwire cord #A10-5025END, the one ground wire is 10 gauge, the other 3 wires are 6 gauge. I will have our website updated to reflect this. Sorry for any…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...

Answer 9

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 10

In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along with…

view full answer...

Answer 11

Aside from the six 15A or GFCI power receptacles (5 interior and 1 exterior) and the breakers/fuses, we have all the parts you need to complete your project. For the power inlet on the outside of your horse trailer you can use the Epicord 30 Amp…

view full answer...

Answer 12

Yes the SmartPlug RV Power Cord #SM86FR that you referenced will stay flexible when the weather is cold. This would not get difficult to wrap up if the temperature was to drop.

view full answer...

Is Box Needed To Install SmartPlug RV Power Inlet?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching