Recommended Replacement Manual Fold Out Steps For A 2019 Lance 1985 TT

Question

Question:

Hi, we have a 2019 Lance 1985 travel trailer. I messed up the steps and had RV.com remove them. They straightened out the mounting brackets and there is 25.375 inches between the vertical brackets. The depth is 13 inches and the trailer takes a 2 step manual pull-out. What do you have that might work for us? My wife is getting really tired of using a step stool. Thanks!

asked by: Michael G

0

Expert Reply:

For your 2019 Lance 1985 travel trailer, I recommend taking a look at the:

-Lippert Manual Pull-Out Step for RVs - Double - 7" Drop # LC432682.

These are two step, manual pull out steps, that measures 25-1/2" between mounting brackets, and is 12" deep.

Additionally, these steps have a maximum weight capacity of 300-lbs and features an easy bolt-on installation.

To ensure these steps will work for you, I recommend you measuring the width and depth of the available space under your door, as well as your entry height.

As long as your entry height is within 21-1/2" - 24-1/2, and your mounting space is less than 25-1/2" wide and 12" deep, then these steps will work great for you.

expert reply by: Bryce D

0

Entry Height Measurement
(click to enlarge)

Answer 1

You may be able to use the TorkLift GlowStep Stow N' Go steps, though it is going to depend on the width of the area you are looking to mount them. You'll want to take a measurement of the mounting area width to determine if the mounting…

view full answer...

Answer 2

We have a couple of 4-step scissor stairs you could use. We have a steel model, #SS04, and an aluminum model, #AS04, and both are 18 inches wide. These stairs mount using an included bracket that looks like #AS2002. So they do not pin into place.…

view full answer...

Answer 3

From what you have described the TorkLift GlowStep Stow N' Go Scissor Steps, #TLA7844, will match your needs. This is for entry heights between 31" and 42". It will set within your door sill width with just under 2" on each side,…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

Yes, you can change the steps on your RV from electric to manual. You would just need to take some measurements after deciding what style you prefer. You can look at steps like the SolidStep Manual Fold-Down Steps #LC791574. This style of step would…

view full answer...

Answer 6

The steps we carry that are the closest to your mounting hole measurements are the Flexco Manual Pull-Out Steps #SMFP-2120. The mounting holes are 20-1/2 by 7 inches. Unfortunately, there aren't any steps that we carry that are exactly the same…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Recommended Replacement Manual Fold Out Steps For A 2019 Lance 1985 TT

Product Page this Question was Asked From

Continue Researching